Availability of 1-7/8 Inch Hitch Ball With a 1/2 Inch Diameter Shank
Updated 05/11/2015 | Published 05/09/2015
Products Featured in This Question
Question:
Im looking for a trailer hitch ball to fit my mower with a 1/2 eye on the pull bar. Its only used to move an empty trailer in the yard. Do you have anything to fit such a small pull bar with a 1 7/8 ball?
asked by: Stephen
Helpful Expert Reply:
We can get you pretty close. The closest thing we offer would be the # C40095 ball from Curt that is a 1-7/8 inch ball with a 5/8 inch shank. If it's possible to enlarge that eye from 1/2 inch to 5/8, I'd recommend going that route. Since you'd only be increasing the hole size by about an 1/8 of an inch, you wouldn't need to worry about removing too much material from the pull bar.
Product Page this Question was Asked From
1-7/8" Hitch Ball - 3/4" Diameter x 1-5/8" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome
- 2000 lbs GTW
- 1-7/8 Inch Diameter Ball
- 3/4 Inch Diameter Shank
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Correct 4-Way Wiring Harness for 2025 Kia Sorento Hybrid SX Prestige
- Q&A: Comparing Trailer Brake Magnets # BP01-225 and # BP01-180
- Q&A: Installation Instructions for Draw-Tite Trailer Hitch 24796 and a 2015 Nissan Altima
- Q&A: What are the Correct Bearings and Races for Dexter 8-201 Electric Drum Brakes?
- Q&A: Bearing Buddy Grease Caps for Hub Bore Dimension of 2.05-Inches
- Q&A: Replacement Hub for Harbor Freight 4 x 8 Trailer
- Q&A: Replacement for ACT-7.5K Actuator on Mastercraft Boat Trailer