Where Does Red Wire of Rocker Switch on a Superwinch LT3000 Go
Updated 05/11/2015 | Published 05/08/2015
Question:
Wiring new winch on trailer and it has a red wire for ignition wire on the rocker switch and remote switch. Since this is on the trailer with a seperate battery what do I do with this red wire? Thanks
asked by: Diane K
0
Expert Reply:
I spoke to my contact at Superwinch and he said that the red wire you found needs to be run to a 12 volt circuit. This is the activation circuit for the winch and does not need a high amperage circuit.
You could run this wire to the 12 volt circuit of the trailer's wiring.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Superwinch LT3000 ATV Winch - Wire Rope - Roller Fairlead - 3,000 lbs
- Electric Winch
- ATV - UTV Winch
- Planetary Gear
- 1.0 HP
- 2001 - 4000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- Wired Remote
- Wire Rope
- Superwinch
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement Shelby 5438 Winch Recommendation for Pop Up Camper
- Q&A: Solution for Replacement Winch for Old Starcraft Lift System
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: Winch Recommendation for Pulling Racecar Up Into Trailer
- Q&A: Electric Winch with Load-Holding Brake to Lift, Hold, and Lower a Popup Camper Roof
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: No Power At Brake Controller On 2007 Chevy Silverado Classic
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: Finding the Right Electric Winch
- Article: My Trailer Hitch Doesn't Fit