Length of Replacement Extra Long Wheel Strap for Yakima Frontloader and HoldUp # Y8880229

Question

Question:

How long are these straps? I need to know if they are long enough to reach around a 4 in fat tire

asked by: Todd R

0

Expert Reply:

The Replacement Extra Long Wheel Strap for Yakima Frontloader and HoldUp, # Y8880229, measures 12-1/4 inches long. I recommend taking a quick measurement of your tire to compare the two.

Please keep in mind that this strap was designed to fit the Yakima FrontLoader Roof Mounted Bike Carrier, # Y02103, and the Yakima HoldUp Bike Carriers, like # Y02443, which do not accommodate a bike with 4 inch fat tires.

expert reply by: Leah S

0

Answer 1

To replace the wheel strap on the Yakima FrontLoader, part #Y02103, you'll need part #Y8880229.

view full answer...

Answer 2

Hey Stan, thanks for reaching out! Here are the inside dimensions of the roof box you're asking about, as well as a linked photo of the roof box comparison chart from the Thule website that you can reference: - Thule Force 3 M #TH47SA -…

view full answer...

Answer 3

The Yakima Fat Tire Straps #Y02470 that fit the TwoTimer and Four Timer hitch-mount platform bike racks will not work on their HoldUp carriers. I confirmed this with my contact at Yakima. The Hold-Up carrier cannot be retro-fitted with larger straps…

view full answer...

Answer 4

Actually according to Yakima the Frontloader part #Y02103 will fit crossbar spreads of 16 inches to 48 inches so you should be fine since your spread is 48 inches.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Yakima, the difference between the Replacement "A" Wheel Tray Assembly #8880796 and Replacement "B" Wheel Tray Assembly #8880797 is the following: "Look at the base of the wheel cup and look at the cut out above…

view full answer...

Answer 7

Hey Greg! Yes, the Rhino-Rack Quick Mount Legs for Sportz Crossbars #RRRLT600H will fit the T-slot rails on your RetraxPRO XR. For a set of four under one part number we have the #RRRLT600. Regarding the clearance, the handle won't clear as is so…

view full answer...

Answer 8

Hey Troy, the Rhino Rack Roof Rack part #Y02-480B-NT that you referenced is designed to fit channel that is basically the same as T-track so in a way the answer to your question is "yes". What T-Track dimensions do you have?

view full answer...

Answer 9

We do offer several parts that are designed to fit the Yakima Raptor Roof Mount Bike Carrier Y02093. The replacement lower jaws for the carrier allow you to mount the carrier to different-sized crossbars. The part number for this is #Y8880054. When…

view full answer...

Answer 10

When determine if you can fully open swing-out doors on your 2022 ProMaster 3500 with the Yakima EXO #Y34ZR, it really depends on how far your doors swing when in the open position. While the 90-degree swing has not been tested spcificially on a 2022…

view full answer...

Answer 11

I have a solution for you but our next size down kit is going to be the 65" Rhino-Rack Vortex Crossbars for Retrax XR Tonnneau Covers item #RRVA165B-RRRLT600 but this is still too wide. From what I could find online the bed of a 2020 Ranger…

view full answer...

Answer 12

Looking at the 2019 Ram we installed these on I'm guessing the 71" bars are what you need but I would measure just to be sure. Run a tape measure across the bed of your 2024 Ram to see what the best size would be for your application. If the…

view full answer...

Length of Replacement Extra Long Wheel Strap for Yakima Frontloader and HoldUp # Y8880229

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching