Proper Mounting Location for Side Marker Lights on a Trailer
Updated 06/13/2024 | Published 05/04/2015
Question:
do the side yellow marker lights have to be along the bottom side edge of the trailer or can I mount them about 14 inches above the bottom edge of the trailer
asked by: Chuck
Helpful Expert Reply:
The proper mounting location for side marker lights such as # MC32AB are as follows:
For rear side marker lights you must have one on each side of your trailer and as far toward the rear of trailer as possible. They will need to be 15 inches or more above the ground.
For front side marker lights you must have one on each side of your trailer and as far toward the front of trailer as possible. These too must be 15 inches or more above the ground.
So, yes, you can mount them about 14 inches above the bottom edge of your trailer.
I included a informative article about trailer lighting and short video review for you too.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: breakaway kit
- Search Results: trailer lights
- Search Results: wiring
- Article: Trailer Lighting Requirements
- Shop: Tri-Axle Teardrop Trailer Fenders - Rounded Edges - Steel - 14" to 15" Wheels - Qty 2
- Article: Trailer Wiring Diagrams
- Shop: Bright Way Trailer Breakaway Kit with Charger, LED Tester, and 5 Ah Battery - Side Load
- Shop: Square Pipe Mount Swivel Jack w/ Footplate - Weld On - Topwind - 15-1/2" Travel - 3,000 lbs
- Shop: Optronics LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Round - Amber Lens
- Shop: Brake Controller
- Search Results: mc32ab
- Video: Comprehensive Review: Tri-Axle Teardrop Trailer Fenders
- Shop: Front Mount Hitch
- Shop: Vehicle Lights
- Shop: Miro-Flex LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red
- Shop: Replacement Flush Mount Rubber Grommet - 3/4" Diameter - Qty 1
- Shop: Replacement Male Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 2" - 5/8" Pin Hole
- Search Results: bearing l44649 and l68149 trailer bearings races seals caps
- Search Results: trailer bearings races seals caps
- Search Results: bearing l68149 trailer bearings races seals caps
- Video: Breaking Down the LED Clearance or Side Marker Trailer Light w/ Reflector
- Video: Detailed Breakdown of the Optronics Trailer Clearance or Side Marker Light w/ Reflector
- Q&A: Where Do Amber and Red Trailer Clearance Lights Normally Install on Trailer
- Video: Trailer Wheel Measurements
- Video: Hands-On with the LED Trailer Fender Clearance Light
- Video: Easy Grease Trailer Hub and Drum Assembly Feature Review
- Video: Hands-On with the Trailer Hub and Drum Assembly
- Q&A: Why Do Some Trailer Tail Lights have 3 Wires and Some have 2 Wires
- Q&A: Recommended 4 inch by 2 inch Clearance Light for Trailer
- Q&A: How to Wire 3 Wire Trailer Tail Lights
on Trailer Lights
Raymond D.
6/13/2024
I have two side markers in the middle of my rv. One on each side. Front and back including clearance lights are correct. Which one, red or Amber for the lights in question