How Do the CIPA Golf Cart Mirrors part # CM01140 Install on a Golf Cart
Updated 08/19/2020 | Published 05/03/2015
Question:
Does the mirror clamp on to the side bar or roof support bar without having to drill screw holes into the bar itself ?
asked by: AK
0
Expert Reply:
The CIPA Golf Cart Mirrors part # CM01140 that you referenced do not require any drilling for installation. They simply clamp around 3/4 inch or 1 inch diameter bars to install.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CIPA Adjustable Side Mirror for Golf Carts - 7-11/16" x 4-5/8" - Square Clamp - Qty 1
- ATV-UTV Mirrors
- Golf Cart Mirror
- Roll Cage
- Clamp-On
- Left Hand
- Right Hand
- CIPA
more information >
Continue Researching
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Are ST145R12 Tires The Same As 4.80-12 Tires
- Q&A: Size Difference Between 4.80-12 Tires and 175/80-13 Tires
- Q&A: What Hitch and Wiring do I Need for My 2025 Jeep Wrangler Sport S Unlimited?
- Q&A: Is it Normal for Timbren To Not be Centered Over Axle Mount
- Q&A: Replacement A-Frame Jack for a Forest River Pop-Up Camper
- Q&A: Compatible Replacements For A Lippert Rhino Box Pin Box On A 2021 Cedar Creek 37MBH
- Q&A: How to Correctly Measure for Trailer Steps
Carole B.
8/9/2020
Can this be installed on the edge molding of my rowboat? The base looks like it could fit on, but could it be bolted on? Is the mirror removable without also releasing the holder? I want to be able to clamp on to go rowing and then remove when I'm finished. Might this work horizontally rather than vertically (as shown)?