Does the 24x60 Cargo Carrier, # 52018, have Pre-drilled Holes to Mount a License Plate
Updated 04/20/2010 | Published 04/17/2010 >
Question:
Is it easy to mount rear license plate on cargo carrier ? Are mounting holes predrilled for license plate?
asked by: TOM P
Expert Reply:
Some carriers have predrilled holes and some don't. Adding a bracket will not be difficult. I recommend using the Gray-coated License-Plate Light with Mounting Bracket, # LP55CB. This brackets comes with a light you can wire to your vehicle to illuminate your plate. Just use a few self-tapping sheet metal screws to attach the bracket to one of the tubes on the cargo carrier and then attach your license plate.
Product Page this Question was Asked From
Optronics License Plate Light w/ Mounting Bracket - Incandescent - Gray Housing - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 8-5/8L x 3-1/4W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: Recommended Top Wind Swivel Jack that Fits a 2-1/2" Diameter Snap Ring Mount
- Q&A: Option For Adding Lights To A 1up USA Bike Rack
- Q&A: Determining Spring Hanger Spacing for Tandem Axle Trailer Fabrication Project
- Q&A: Trailer Spring Hanger Spacing for 35-Inch-Apart Tandem Axles
- Q&A: Availability Of 33" Ark Stabilizer Jack And Dimensional Diagrams Of Similar Ark Corner Steadies
- Q&A: Overall Length of the 24" and 30" Ark Drop Down Corner Stabilizer Jacks
- Q&A: Diameter of Curt Round, Snap-Ring Swivel Jack Crank Tube
- Article: How to Fix a Bad Trailer Ground
- Article: Trailer Wiring Diagrams
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)

