Thread Size of the Wheel Cylinder part # BP17-030
Published 04/21/2015
Question:
would like to know the tread size for the hookup of the break line? Thanks
asked by: Eric K
0
Expert Reply:
The wheel cylinder part # BP17-030 that you referenced uses the standard thread sizes for trailer brake line kits, 3/8"-24.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Wheel Cylinder - 10" and 12" Single Serve LH
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- Wheel Cylinder
- 10 Inch
- 12 Inch
- Uni-Servo
- Redline
more information >
Continue Researching
- Q&A: Availability Of LM12749 Bearing
- Q&A: Brake Controller Plug Location on 2021 Jeep Grand Cherokee
- Q&A: What is Difference Between Uni Servo and Duo Hydraulic Brake Assemblies for Trailer
- Q&A: Replacement Bearing Race and Grease Seal For Trailer Hub
- Q&A: Replacement Orifice Fitting For A Titan Disc Brake Actuators
- Q&A: Compatibility of Parts for Military Trailer
- Q&A: Recommended Replacement 205/65-10 Tires for a Triton Snowmobile Trailer
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Lighting Requirements
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs