Tall Trailer Suspension Hanger with 9/16 Inch Diameter Hole
Updated 04/09/2015 | Published 04/08/2015
Products Featured in This Question
Question:
Hi! I am looking for axle hangers like this to lift my camper. Im just wonder what the thickness of the metal is? Also wondering if you make one with these same dimensions just with a 9/16 hole instead of a 3/4 hole? Thanks
asked by: Jeff
0
Product Page this Question was Asked From
Center Hanger for Double-Eye Springs - 5-7/16" Tall - 3/4" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- 3/4 Inch Diameter
- 5-7/16 Inch Tall
- Tandem Axle
- Triple Axle
- Redline
more information >
Continue Researching
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Parts Needed to Convert a Torsion Axle Trailer to a Tandem Spring Axle
- Article: How to Raise Your Travel Trailer Height
- Q&A: Can Fifth Wheel Trailer Height be Raised If Axles Are Already Flipped
- Q&A: Recommendations for Raising Trailer to Add Clearance for Larger Wheels
- Q&A: Can a Travel Trailer be Lifted no More Than Three Inches Without Conversion Kit?
- Article: Where to Position the Trailer Axle?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement Window Trim For 3/4" Track On A 1984 Avion Vintage Camper
- Q&A: Recommended RV Window Seal Replacement Based On Side Profile
- Q&A: Recommended Comfort Ride Leafspring Kit for a Trailer w/ 6,000 lbs Axles
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Double-Eye Trailer Suspension System Review