Winch Recommendation for a 2010 Can Am 650 to Replace Warn Winch
Updated 03/10/2015 | Published 03/09/2015
Question:
I have a 2010 canam 650 and im changing out my warn winch with a superwinch.can I use the same wires from old winch or do I have to run new wires.it was a factory mounted winch.does the winch have a built in solenoid or does it run off the bikes
asked by: Todd
Expert Reply:
The only way I can safely recommend you install the Superwinch Terra Series ATV Winch - Wire Rope # SW1125220 on your 2010 Canam 650 is to use the wiring kit that comes with it. The wiring kit does include relays and circuit breakers that are rated for the amperage draw of this winch. What you have on your Canam may be properly rated, but without knowing for certain I can't make that recommendation.
I attached an install video for this winch kit for you to check out as well.
Product Page this Question was Asked From
Superwinch Terra Series ATV Winch - Wire Rope - Roller Fairlead - 2,500 lbs
- Electric Winch
- ATV - UTV Winch
- 1.0 HP
- 2001 - 4000 lbs
- 11 - 20 lbs
- Fast - 10 or More fpm
- Wired Remote
- Wire Rope
- Superwinch
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: 1,200 lb Electric Winch that Uses AC Power
- Q&A: Looking for an Electric Winch to Raise a Platform Into the Sacred Man Cave
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Torque Spec for Tightening Trailer Brake Assemblies to Trailer Spindle
- Q&A: Recommended Replacement Axles For Tandem Axle Boat Trailer
- Q&A: 25-1/4 inch Leaf Spring Recommendation for Travel Trailer with Tandem Axles
- Q&A: Recommended Leaf Springs, Shackle Kit, and Wet Bolts for a Trailer w/ 4,400 lbs Axles
- Q&A: 25-1/4 Inch or 26 Inch 4,000 lb Double-Eye Spring For Trailer With 25-1/2 Inch Eye Spacing
- Article: Finding the Right Electric Winch