Can the Replacement Handle Latch # 158-101 be Welded On
Updated 03/02/2015 | Published 03/01/2015 >
Question:
MY existing latch was welded to approx. 1inch arm and weld broke or was broken. Will this handle work ? thanks for your help.
asked by: Ken B
Expert Reply:
The Replacement Handle Latch # 158-101 that you referenced was designed to be bolted on but there's no reason it couldn't be welded on as well.
I spoke to my contact at Redline and he informed me that the Replacement Handle Latch # 158-101 that you referenced is made from galvanized steel so you will need to weld in a well-ventilated area.
Product Page this Question was Asked From
Replacement Hasp for Polar Cam-Action Latch Kits - 1" Wide - Zinc-Plated Steel
- Trailer Door Latch
- Hasps
- Lock Not Included
- Bolt-On
- Metal
- Polar Hardware
more information >
Continue Researching
- Q&A: What is Torque Spec for Castle Nut of Dexter 3,500 lb Axle
- Q&A: What Trailer Wiring do I Need for My 2020 Highlander without Factory Tow, with Connectors?
- Article: Trailer Wiring Diagrams
- Q&A: Possible Replacement for Trostel 300-156-6 Seal
- Q&A: What is Difference between Trailer Mate and Curt Hitch for 2026 Hyundai Palisade
- Q&A: Trailer Wiring Harness for a 2009 Ford E350 Van
- Q&A: Picture of Gorilla-Lift Utility Trailer Tailgate Lift Assist Installed on Bifold Ramp Trailer
- Q&A: Recommended Replacement for Model 70LP Surge Brake Actuator
- Article: How to Measure for Trailer Hitch Drop
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: Most Popular Wheel Bearings
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV

