Torque Specs for the Installation Hardware of the Curt Hitch part # 13364
Published 02/18/2015
Question:
What is the spec for the bolts on this install
asked by: Gord M
0
Expert Reply:
The torque specs for the hardware that comes with the Curt Hitch part # 13364 that you referenced are in the installation instructions that I have attached.
Since we link the instructions directly from the manufacturer and they are subject to change we avoid posting the torque figures for liability purposes.
I also attached an installation video for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Can You Convert 4 Way Plug To Work With Trailer Brakes?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring Instructions For A Dometic RV Water Heater Single-Panel Control Switch
- Q&A: Will Two Sets of the Erickson ATV E-Track Tie-Down Kit Work for a 3K RZR
- Q&A: Weight Capacity of Erickson ATV E-Track Tie-Down Kit # EM09160
- Q&A: Bearing Replacement Recommendation for Timken 07100
- Q&A: How Much Clearance Is Lost When Switching To A Gen-Y Gooseneck Pin Box
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Installation Tips
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace