7-Way Recommendation for a 2015 Chevy Colorado to fit OEM Blank in Bumper
Published 01/14/2015
Question:
will this fit in the blank on the drivers side bumper where the OEM one fits see pic?
asked by: Tom
0
Expert Reply:
The Pollak 7- and 4-Pole Trailer Connector Socket # HM40975 should fit in the socket at the rear of your 2015 Chevy Colorado. You would just need to remove it from the bracket it and it would fit right where the blank is on your truck.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 4 Flat
- 7 Blade
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Do You Have the Replacement Hardware for My Curt Hitch?
- Q&A: Recommended Hitch and Wiring Harness for a 2025 Bronco Badlands
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Hitch for a 2024 Toyota Venza That Wont Affect the Hands Free Lift Gate
- Q&A: Can Fuse Tap be Used to Acquire Brake Signal for Brake Controller Install of 2017 Toyota Highlander
- Q&A: Replacing a Magnum MS2812 With a Victron MultiPlus II or Quattro II Inverter Charger
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Curt C96GJ Wiring Kit Compatibility With Factory 4-Pin On 2025 Ford Ranger
- Article: My Trailer Hitch Doesn't Fit