2011 Jeep Wrangler Off Road Lights

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Because the face of the magnet rides against the armature (inside) surface of the brake drum, any grooves that had previously been worn into the armature surface will cause the magnet to wear unevenly. For optimal braking performance, you want…

You are correct the hook ups are for the lights on the Blazer LED Cube Light Kit #BL28VR. The different ratings are for each of the circuits. The lights that come with the kit will fit onto the smaller connections allowing you to connect more…

Yes, the Blazer LED Cube Light Kit #BL28VR can be used on your 30 amp RV as long as you have a 12 volt wiring system which this light uses. As far as how many of these lights you can hook up each remote is capable of controlling up to 4 of these…

Hey there Stormy, I think we can figure this out, as there are a quite a few options. First,…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

For a replacement circuit board you can use the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents #MA10A04751KS. We have confirmed with MaxxAir that this is the correct for what you have.

I hope I got the right measurement for you Roberto. I included a image with the measurement points that I took on the CargoBuckle Ladder Rack Straps #CB32MR below. If you are needing a different measurement please let me know.

Since your 2020 Acura RDX did not come with trailer wiring you are going to need the T-One Vehicle Wiring Harness #118804. Then you will be able to connect and pull your trailer with a Ball Mount #DT49MR. For your utility trailer if you are looking…

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

The Curt Trailer Hitch Receiver #C77NR will fit the 2023 and 2024 Kia Niro PHEV. Gas models require lowering the emissions canister so the hitch can fit. We have only had the one instance where someone felt the need to completely remove it, but…