1997 Chevrolet C/K Series Pickup Off Road Lights

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the…

Hey Peter you are right that the Opti-Brite LED Strip Light #OPT32ER does require its own separate switch. For that you could use really any on/off switch, my suggestion is the Single Rocker Switch #37212585 and the faceplate #37212845. If you are…

You are correct the hook ups are for the lights on the Blazer LED Cube Light Kit #BL28VR. The different ratings are for each of the circuits. The lights that come with the kit will fit onto the smaller connections allowing you to connect more…

Because the face of the magnet rides against the armature (inside) surface of the brake drum, any grooves that had previously been worn into the armature surface will cause the magnet to wear unevenly. For optimal braking performance, you want…

Yes, the Blazer LED Cube Light Kit #BL28VR can be used on your 30 amp RV as long as you have a 12 volt wiring system which this light uses. As far as how many of these lights you can hook up each remote is capable of controlling up to 4 of these…

Hey there Stormy, I think we can figure this out, as there are a quite a few options. First, let's just discount the heavy-duty rack, as those are just oddly shaped crossbars and there's nothing HD…

Only a small part of the underneath bumper panel on your 2024 Kia Niro is needed to install either the Curt hitch that fits, which is the following part number: - Curt Trailer Hitch Receiver #C77NR I added a portion of the instructions which shows…

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with…

For a replacement circuit board you can use the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents #MA10A04751KS. We have confirmed with MaxxAir that this is the correct for what you have.

I hope I got the right measurement for you Roberto. I included a image with the measurement points that I took on the CargoBuckle Ladder Rack Straps #CB32MR below. If you are needing a different measurement please let me know.

Since your 2020 Acura RDX did not come with trailer wiring you are going to need the T-One Vehicle Wiring Harness #118804. Then you will be able to connect and pull your trailer with a Ball Mount #DT49MR. For your utility trailer if you are looking…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…