1987 Jeep Wrangler Jeep Hardware

The Blue Ox High Low Adapter part #BLU53XR was designed only for use in flat towing setups where there isn't tongue weight present so its not rated for that. This is solid shank designed to fit the…

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the…

As long as you have at least 6" of clearance from the center of the hitch pin hole for the OEM hitch to the rearmost part of your 2021 Jeep Grand Cherokee you can definitely use the MORryde Jerry Can…

I went ahead and confirmed with MORryde that the plastic trim piece shown in your provided photo is the standard trim molding on your 2006 Jeep X Model. With the Fender Mounted Jerry Can Holder for Jeep Wrangler TJ and YJ #MR69MR, you…

No you can not use the long ends to mount the platform. The platform #RR82TB can only be mounted to the legs using the underside crossbars. There is no other spot on the platform that can accept legs.

For a 2023 Jeep Wrangler 4XE you'll need the following components: Baseplate: Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These custom-fit baseplates are designed to work with factory bumpers,…

According to my Classic Accessories representative, their UTV Roll Cage Organizer is 47 inches long by 7-1/2 inches tall by about 2 inches deep. My Classic Accessories rep tells me that the Organizer fits just about every UTV, but he…

The Saris Swing Away Hitch Extender for Bike Racks #SAR36VR has an overall capacity of 250lbs (rack and bikes) so it could technically accommodate two 85lb e-bikes as well as a rack, but the bike racks confirmed to be compatible with this extender…

The Ark Drop Down Corner RV Stabilizer Jacks - 33" #ARK77FR is the same as their part number: XODDS850BUS.

Since you will be at a campground the best way for you to move an enclosed motorcycle trailer is a dolly and a great option is the Trailer Valet 5X Swivel Jack and Trailer Mover #STC-V211 because it is a combination jack and dolly that has rubber…

I think we may have a solution that will work for you as we offer a very wide variety of spare tire carriers. However, I would really need to see a photo of you setup in order to offer the best advise. The issue you will run into trying to find a…

Roadmaster Rear Anti-Sway Bar part #RM-1139-146 can only be installed in one orientation. It is not designed to be installed upside down. I have attached a photo of what the installation should look like.