2021 Jeep Wrangler 3.6L V6 Engine Exhaust

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hey Brad, yeah you would need a hitch extender with the Thule ReVert bike rack part #TH83VA to allow the tailgate of a full size truck to open. For that we have the Gen-Y Hitch Extender part #e88YR which is 8 inches long. What kind of bikes will you…

Hey Chris, Our Fitguide can be a bit confusing sometimes. Essentially the whole category is broken down into whether they fit diesel or non-diesel models. Since the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR fits both gas and diesel…

Hey Jack! First of all, congrats and the soon to be new travel trailer! Ideally the correct WDS is going to put your trailer's tongue weight right around the middle. It looks like your trailer comes in at 9,630 lbs, so if we figure 15% of that…

Hello Dan, thanks for reaching out. The Firestone #F2550 for the 1999 Ford F-250 2WD will be compatible with the B&W Turnoverball gooseneck hitch. The brackets are designed specifically to be compatible with in-bed hitches like the B&W, so if…

Hello Phillip, thanks for reaching out. Yes, the Reese Dual Cam #RP26002 WD system can be used with a Reese Friction Sway Control #83660. As long as the head of your WD hitch has the pre-welded tab for the sway control ball (pictured below), the…

The inner diameter of the expanded ends of the part #CAM44812 is 1.53 inches and the outer diameter of the non expanded end is 1.51 inches. So basically this setup is designed to either slip into a 1-1/2 inch pipe or slip over a 1-1/2 inch pipe.

I have attached a drawing from the installation instructions for the rail kit part #C16430-204 you can check out. As you can see in the attached drawing I noted the carriage bolts and where they are located on the rails when installing. Please note…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Yes, the TorkLift SuperHitch Magnum Trailer Hitch Receiver #TLD1111-30 will fit your 2024 Ram 3500 long bed dually. This hitch fits both the short bed and long bed including dually and single rear wheels. It will replace your factory hitch.

For your generator exhaust, the Camco Gen-Turi Replacement 30" EMT 90-Degree Discharge Pipe #CAM44812 is designed to be used with the Camco Gen-Turi RV Generator Exhaust System #CAM44461. With that being said, we have not tested the #CAM44812…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…