ADCO makes sizing simple for smaller rigs with covers built for 15 feet long bodies. Installation is straightforward, and multiple underbody straps help cut down flapping in strong winds. For best fit, measure only the trailer body and do not include the tongue.
Yes, side zipper panels allow entry without removing the cover. There's a front panel for a front door and a rear panel for a rear door. Line up the door area before final tightening so the zippers land where you need them.
Pad sharp spots like rain downspouts; a small hole in a tennis ball placed over the downspout can help prevent tears. Secure all straps to limit movement. After heavy wind or monsoon-like rain, inspect the roof fabric and address any abrasion points before re-covering.
Choose a cover by the body length of the trailer, not the overall length with the tongue. Covers aren't meant to go over the tongue, so subtract that when measuring. If you have a ladder or roof items like an A/C or vents, the roof section has room for them—just center the cover and cinch it evenly.
It can reduce flapping when tightened properly. Multiple straps running under the trailer and front/rear straps help secure it, and snug-fit corners add stability. One fit saw minimal flapping even in gusts over 50mph+. Tighten all the straps and recheck after storms.
Yes, it installs easily for many. Using two people helps, and the weighted toss-under straps make routing the underbody straps simpler. If climbing ladders is tough, take it slow and plan your drape. Reviewing the instructions and photos before starting can make it smoother.
Pop-Up Camper Cover
Toy Hauler Cover
Travel Trailer Cover
Filters
