Most Popular 12 Inch Fore/Aft Travel for 2021 Ford F-250 Super Duty

my companion 5th wheel hitch(rvk3370) hitch was delivered on 3/11, I installed it in a couple hours on 3/12. It was a piece of cake, the delivery was made with a lift gate truck that I back my truck up to and had the driver lower the lift gate down onto my tailgate, I unpackaged the hitch and was able to Maneuver it by myself into the puck system on my truck, I have the slider hitch so much heavier than the standard one, but still very easy for my 65 year old body to handle, the B t W was the only hitch I considered because of the ruggedness and quality of their products my truck is a 2023 Ford F 350

Click to Enlarge

Will at eTrailer.com did a great job walking me through the 5th wheel hitch and air lift options that I needed. The B&W Companion Slider Hitch installed like a charm, and looks to be great quality! Nice fit and finish, B&W.

Click to Enlarge

Got here about four days early. Packaging was great. Haven’t used the hitch yet, but have used the Q24 for ten years. I really like Curt products and etrailer has the best prices I have found. Great service. Highly recommend.

I gave it 4 stars only because I haven't experienced the operational aspects of the 5th wheel hitch yet. That will happen in the coming months when we put the hitch to work. The packaging was a little beat up but all the pieces were in great shape and the nuts and bolts were there. The assembly went well, directions are easy to follow step by step. The only issue I had was with the 4 bolts that connect the plate assembly to the slider assembly. They were in an award place which made it somewhat difficult to start all 4 and tightening them without the correct tool. You really need a ratchet wrench to snug them up. I couldn't get to them with my 1/2" torque wrench to I used blue lock-tight a long with the supplied lock washers and hand tightened them the best I could which should be fine, I'll check them along with the other 8 on the slider assembly after a couple of trips to make sure all is good. There is some timely maintenance you need to pay attention to, that I haven't experienced on other hitches but it's no big deal. From a construction standpoint, it's well built, I like the cast pieces, not alot of welds to worry about or check on from time to time. The slider assembly is well thought out and works as it should with a fool proof locking mechanism. The double jaws should provide ample clamping power. The pivoting head also appears to be well thought out and should provide plenty of tilt for those award hookups you find yourself in from time to time. So far I'm please with the equipment and the price I paid for it. Not to mention FREE SHIPPING. Your definitely getting your money's worth in a sound, well built 5th wheel hitch assembly.

Extremely easy install. You will need a torque wrench that’ll go up to 110 ft/lbs. glad I did my research and went with the B&w gooseneck hitch in anticipation of getting this 5th wheel companion hitch at a later time.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Fast shipping and the box was in perfect condition. I appreciate the amazing customer service. They were friendly and had a good attitude when I called with questions. I look forward to shopping with them in the future. The shipping company called ahead of time and scheduled the delivery because it was such a large item they were friendly and was within their timeframe. Thank you etrailer.com I appreciate it.

Click to Enlarge

So far it works great. Only pulled in a short distance and backed it up into my driveway. Make sure you have help lifting this. Very Very heavy. Directions were average but got the job done. Love the extra turning radius on my short bed F250. Make sure all the parts are there. The handle to release the king pin off the hitch was not in the packaging. The box that the hitch and slide came in were all in tacked and looked good. Emailed etrailer and within a few hours they sent were processing the order for the handle. Arrived in 2 days. That's great customer service.

Click to Enlarge

Looks like a received a returned hitch. All my hardware is missing. And still waiting on one box. The sliding rails. Starting off to a bad start.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Curt A16 with Slider base for Ford OEM Pucks I went through a good bit of anxiety after trading my 2013 F-250 for a 2018 F-250 due to the height of the 2018. I did not pay close enough attention to bedrail and rear height and I was beside myself sick over it so this review might be a bit long while I explain my journey. I replaced a 2013 F-250 4WD with a Reese Pro Series 16K square tube slider universal mount with a 2018 F-250 with OEM pucks. I pull a 2015 Prime Time Crusader 315RST. I measured, I had boards with levels, mock up on hitch height, I read every forum and article I could find and still I was worried I had made a big mistake. Finally, I called eTrailer and talked to Molly and she had, (or went and got) plenty of answers as I had narrowed it down to the B&W BWRVK3370 20K Companion Slider and the Curt A12. I decided to not go for the “the most expensive is better” and went with the Curt A12 saving me about $300. The 20K B&W was the smallest they had and with an F-250 I would never really come close to that weight before I passed the GCVW limit so it made no sense. The Slider base for the Curt says it is the same base used up to 24K so if I ever do I can just buy the new head I believe. Ordered on a Saturday it arrived on Thursday at noon. No issues with shipping at all, the hitch came in 2 boxes strapped to a pallet. No damage like others experienced. Assembly took me about an hour because it is heavy and awkward to line up the slider linkage but all in all nothing too difficult. I set the hitch head mount at the 2nd from the bottom (18 inch) hitch height because I had measured the truck and camper and was worried about having 6 inches of clearance camper to bed rail. Turns out on a 2018 F-250 4WD at the 18-inch level on the hitch I have 8 inches all around and 7 inches at the highest point on the tailgate. After I installed the hitch and put the camper on the truck and applied weight I got about 3-4 inches of squat, which made the already rear high truck sink to near level. I do have more nose high attitude on the trailer than I had before but it was not terrible. I moved the height adjustment down to the 17 inch (lowest) today to lessen the nose high attitude by another inch and I have 6+ inches clearance still. The hitch. Like I said before I had a Reese Pro Series 16K slider and it was noisy as hell. Kingpin clunk starting and stopping, creak at every bump and turn. I put the Curt A16 in and took the trailer for a drive with the rear slider window open and heard nothing. Absolutely nothing. No start/stop clunk, no creaking, nothing. Hook up was very easy and the interlaced kingpin jaws make visual check very easy. Operating the slide takes a bit more effort but it worked fine and locked securely. It did not latch back to maneuver and then back again to towing automatically like the video without jostling the handle a little but I am sure it will once broken in and I grease it a bit more. The puck system was easy to adjust and make a solid connection to the truck with no play. I could not be more pleased with the hitch. Cons- The hardware was packaged like one would expect and it was all there but the bolt for the center connection of the slider linkage was different than the handle and passenger side joints. It is too small and caused a lot of play. I used it anyway but it allows play in the handle and not firm for unlatching. I will replaced it today and now it works great. eTrailer is now my go to store for trailering supplies.

Click to Enlarge

Click to Enlarge

2017 F250 curt A16 slider Ford prep package

Click to Enlarge

Click to Enlarge

Click to Enlarge

There was a snafu on the delivery of this, like it ending up 1000 miles from my house on the first try, and then the delivery company getting mad at me for not having a forklift at my house. Since I just got this yesterday I can't say much ab out it yet, I am still trying to install it. I do suggest a hoist in your garage if you plan on removing this hitch at all, it is heavy. It looks to be in great condition though! I can't wait to get it attached so I can give it a test drive on a 2 hour trip. I can tell you that two RV retailers suggested this B&W hitches, so I have high hopes. With all the products on the market today, to get recommendations from two different companies that installs them, is impressive.

From the start,the folks at etrailer were very courteous and helpful. I called many times during the decision making process and everyone was always right there to help. When I finally decided to purchase the B&W 18K Patriot w/slider Bailey was there to help with the order. She explained the free freight shipping and it was a done deal. It arrived 1 day earlier than stated, as soon as I opened the cartons it was in fact the good ol' American made quality I was accustomed to growing up. I proceeded to install on the B&W rails I purchased and installed locally on my 2022 F250 Lariat/ Tremor.I had a small hick- up with the install and etrailer gave me B&W's # as they like to handle issues themselves. Stephanie at B&W was just as courteous. Overall a very pleasant experience. The Patriot was basically plug and play. I then connected my 2021 Grand Design 303RLS Reflection and rolled down yhe road. What a smooth and quiet ride, loved it! I would definitely recommend etrailer and their products. Thank you all that helped.

Click to Enlarge

Click to Enlarge

Bolt coming out on roller wheel, rusts very quick, and locking arms don’t pull that well or easy from outside of the bed

Doesn't operate as easily as I hoped. Sticks when trying to slide which means jumping in and out of cab many times. Also its heavy as it should be,but it doesn't come apart easily for removal in two pieces that can be lifted separately. You need a winch to remove it safely. Its a pain in the you know what. I like my old two piece hitch better. I could take it in and out in a few minutes, but it won't work in my new f350.

Etrailer sent me a one year follow-up email. Since purchasing this I've used it to tow our 11k lb camper about 5k miles. The hitch and slider have worked exactly as they should and I have no complaints.

Click to Enlarge

Well, I haven't towed with it yet but we'll see how that goes. I purchased this hitch because I needed to drop the height as much as 6 inches. My previous hitch was dropped to the lowest setting and still 17 inches high! This E16 goes down to 14 inches... Assembly was straight forward and all pieces were present ( even 4 big washers which were not illustrated anywhere in the instructions as to where they went) The hitch seems well built but the welder needs to be more thorough in cleaning his Slag (got my finger good when I picked up the top plate) Stickers were falling off everywhere (my heat gun fixed those) But a couple notable design flaws... The top cradle for the 5th wheel plate is a triangular shaped arch and the top plate has an axle which is perfectly round. So when the 5th wheel assembly is down in the cradle, there are only two little points of contact instead of the cradle fitting uniformly around the axle rods...we'll see what kind of wear this causes. Next, the green ring on the indicator rod looked like a 3 year old toddler wiped lipstick on it. (Green paint is supposed to be in the little groove cut in the rod but instead, is smeared all over the end of the rod) Lastly... The side plates have a two rows of holes for height adjustment...I have installed the bolts to position the overall height at the lowest possible setting. However, there are two more holes in the tie plate but the casting prevents the sideplates from dropping down even lower. Definitely confused as to what the extra holes are for and disappointed that I can't drop this even lower... Definitely seems heavy duty, but again, I haven't towed yet, so hopefully the play in the base rails doesn't translate into obnoxious clanking and rattling.... If so, I will definitely be doing another review

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Works as expected. Installation was almost perfect. I had to do a little physical persuasion on one clip to get it to line up correctly but nothing a big hammer could not fix. But with confidence from a reliable company.

Click to Enlarge

This is our send fifth wheel hitch. We had issues with the first one due capture plate. This one doesn’t require one. Live and learn. This one is worth spending more money due to its quality. They also provided us with great customer service. We definitely recommend this product as well as this business.

Great Hitch, very happy with this unit. Have pulled the 18K lb fifth wheel over 25K miles (Florida to Idaho, back to Florida and now Alaska). We have covered many rough roads and challenging situations, without problems and have never had a bad couple. The hitch indicator on front of head gives a clear indication of latching condition, and the latch handle has a locking pin for added protection. This pin is the only issue I have had, which can be trapped under the slide plate if your truck is at an angle (beyond about 35 deg) from the rv. I make it a point to pull this pin prior to backing if I am the least bit concerned. This is a great hitch! Excellent quality and it's made here in America.

Click to Enlarge

This is very well built and operates great. Once I got the first rail positioned and mounted, everything else was very easy. The R20 slider came in a single box and was very heavy. The packaging is not suitable for the weight. As others have also reported, the package was completely demolished when it arrived. Thankfully , all the part’s made it okay and nothing was damaged. I love the product.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Purchase and delivery went very smoothly and was right on time. Hitch was packaged very well. Works exactly as advertised. Got the slider hitch as recommended by eTrailer, good recommendation. Due to the weight of the hitch it requires two people or hoist mechanism to install it.

This hitch is very easy to use and moves flawlessly along the slide rails. And talk about sturdy... this thing is solid. Very well engineered.