# 1
Swagman XTC2 Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
Excellent product! No need for an additional piece to accommodate my ladies bike. I can easily open my hatchback without removing the rack.
The service and attention is terrific. I'm not thrilled with the bike rack, however. As I drive, I have to watch it rock from side to side, even with the stability strap--and that is unnerving. Unfortunately, it's the only rack that fits my Mazda 3, so I am grateful to have even that.
# 2
Swagman XC2 Bike Rack for 2 bikes - 1-1/4" and 2" Hitches - Frame Mount
This was a present for my daughters Mazda 3. We like how easy it is to mount the bikes and that you don't have to take the frame bag off the bike to use it. It is a good option for someone looking for an affordable entry level rack for occasional use.
I bought this rack and a hitch from Etrailer to carry bikes on the back of a 2015 Mazda 3 hatchback. The Etrailer website was GREAT in helping to pick the products. The rack arrived on time as promised. I opted for the XC2 over the slightly more expensive XTC2 because I didn't like the XTC2's plastic straps (in my limited experience, similar plastic straps end up stiffening and breaking over time). As long as the 'hooks' are pushed firmly down on the bikes, the bikes are held very steady. I like that the 'hooks' are held down by a ratchet mechanism rather than the tightening knobs that many competing racks use. The hatch door can just barely be opened when the tower and wheel racks are in the upright (folded up) position. Of course, with bikes on the rack, the hatch cannot be opened. It rides very well on smooth roads. It seems to wobble quite a bit when I jiggle it by hand, which makes me wonder how it would do on rough roads, but the construction seems strong so I won't worry about it. I think any hitch mount will wobble just as much. So far, I've made one 100 mile trip and I'm completely pleased. One more note: the tire racks have hand knobs to tighten the racks into place. At first they were really hard to tighten and didn't seem to hold well. Then I discovered I had put the tire racks on upside down, hence the knobs were on backwards. For some reason it makes a BIG difference! Once on correctly, the knobs worked perfectly. Read the instructions :-)
# 3
Swagman Trailhead Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Tilting
Great bike rack. Sturdy support for up to two bikes. Can rotate the support arms down when you aren't hauling a bike to minimize the obstruction of the back window.
Easy to install, saved quite a bit compared to the big brand name products. The big name products have some easier mechanisms to fold up and down but considering how much I saved, I don't have any complaints.
# 4
Thule Hitching Post Pro Bike Rack for 4 Bikes - 1-1/4" and 2" Hitches
The good: I like the way the bikes are held in and the ability to add the upright adapters to the bike frame holders. The straps are quality too. For a jeep with a spare tire, this is the perfect length to clear it. This rack is 5 stars from the bike holders to the base of it. The bad: the 2"receiver adapter and bolt are insufficient. I wish they made this in a solid 2" hitch. The entire setup is held into the receiver by a very short bolt. It only goes about half way into the receiver tube. So your hitch is only "secured" on one side. A hitch pin or bolt should go through the receiver tube completely imo so it can be secured on the other end with a retaining clip or nut. Because this only goes in the one side, the entire weight of the rack plus bikes are held tight to one side of the receiver by the undersized bolt and washer. A few bumps down the road and that bolt loosens. Now instead of distibuting the weight of the rack and bikes on the receiver and post, it's completely up to the bolt to keep you from losing the rack. The bolt threads get damaged too. I took this down a dirt road and nearly lost everything. I had to buy my own bolt with hd fender washers and lock washers to correct this. Thule should've provided this from the start. The current short bolt design where only one side of the receiver secures the rack is unacceptable. This rack is 1 star at best for the connection to the receiver.
I bought this bike rack back in April but wanted to make sure I used it to give the best review. First I want to say I did a lot of research on bike racks and found this one to be the best one to fit my needs. The best price I found was on etrailer.com, at the time it was When I called the customer service to place my order, I spoke to Dan. He was very pleasant on the phone and took the time and listened to what I needed and understood my concerns. I ordered the bike rack and also ordered the Thule Snug Tite Hitch Lock and Anti-Rattle Device and the Thule Cable Lock w/ One Key System Lock. Dan suggested I also get the Thule Bike Adapter Bar, which I never even thought of getting. Delivery was in about two business days, which was really fast and at the time of order they were running a special free delivery over $99. When I went to put it together I noticed I was missing the flat cap screw M6 x 16mm, part number #853-5787-02. I emailed Dan and within 24 hours received an email that the part was sent out and also in the email their was a link to track the order. After I received the part I did notice that the flat cap screw was actually in the 2 inch adaptor sleeve. The instructions were very easy to read, and it took me about 20 minutes to put together. I did have an issue when I positioned the stinger into the cradle, with the 8mm locking nut, it was not staying tight and when I took it off I noticed the threads inside were gone, so I ended up going out to Lowes and buying a new one and its holds perfectly fine. I also had a question about that part because it is not a locking part and was worried someone would try to steal the rack. I contacted etrailer.com to find if they make a locking device for this and they said no but I can contact Thule to double check, I'm still waiting for an answer back from Thule. The weather finally broke and we installed the rack onto my hitch, tightened it and it doesn't rattle. When I finally used the rack and put my bike on, it did sway a little but at 50 mph I was very happy with it. The trailer comes out just enough away from my car that I do not have to fold completely out and I can open my trunk with no issues. I am very happy with my purchase and had a great customer experience with Dan. Would highly recommend ordering from them to anyone.
# 5
Swagman Chinook Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
Very study and enjoy the locking systems included. However I was a bit disappointing in a few parts of this hauler. The wheel housings being make of plastic vs metal like everything else has me a bit concerned on the lifespan since when you set it down the rack typically rests on the housings. Also one of the bolts holding the cross bar is the absolute minimum possible, so with a slight out of tolerance in the bend angle of the center housing, it was a significant effort to install the nut (I had to bend the lock-washer to be much closer to flat to get access to a couple threads on the bolt). Lastly I wish the locks between the locking hitch pin and the locking vertical hooks were on the same key. Despite the disappointments, it fits virtually all sizes of bikes, securely, and includes excellent features for the price point.
Superior fit and quality of materials. Packaging was thoughtful, easy to follow instructions.
# 6
Kuat Beta Bike Rack for 2 Bikes - 1-1/4" Hitches - Tilting
I was looking for a light weight bike rack for my 2015 Honda Accord. Your videos stated that the Kuat Beta was light and easy to install. You were right. I opened the box, read the instructions, and had it installed in about 10 minutes. I don't use a rack lock. It is so easy to pop on and off the hitch that I keep the rack in my car trunk.
We've been using this bike rack with a 1.25" Draw-Tite receiver hitch (also purchased from etrailer) on a 2012 Prius C for a month with no problems. As shown on the pictures, it fits two bikes very well, even one with a baby carrier. I chose this model based on recommendations from etrailer that it can be easily detached from the car without tools. True to their word, it is very easily detachable from the hitch and folds up nicely to fit in your garage/closet/storage area. Basically, it uses a hand tightened ball bearing mechanism to secure itself into the hitch receiver, and then uses a 3/8" hand locked pin as a safety device. You can install and de-install this rack in just a few minutes. During driving, there is little noticeable vibration from this rack, even on rougher roads or speed bumps. The only downside is that the holes on the receiver hitch do not align perfectly with the holes on the bike rack (see picture). I believe a few other reviewers also noted this issue. There is enough room to fit the safety pin, but not quite enough to fit a 1/2" hitch lock. I called Kuat to ask them about this and the rep told me that not all hitches will line up with this rack. Kuat, coincidentally(?), sells a hitch lock that is also 3/8" (same size as the safety pin) and still fits.
# 7
Swagman Trailhead Bike Rack for 3 Bikes - 1-1/4" and 2" Hitches - Tilting
Easy to install, saved quite a bit compared to the big brand name products. The big name products have some easier mechanisms to fold up and down but considering how much I saved, I don't have any complaints.
Hollywood Racks Hitch Bike Racks Review - 2017 Mazda 3
Hi everyone, it's Evangeline here at etrailer. And today, we're looking at our Hollywood Racks Destination two-bike rack here on our 2017 Mazda3. So the Hollywood Racks Destination bike rack is a really good bike rack if you're looking for something that is a platform rack without being too expensive. So this is a good, affordable bike rack, which creates a platform, making for a nice, sturdy platform for your bikes, making for a smoother ride for your bikes as you bring them to your next adventure. So let's take a look at the way our bike is mounted to our bike rack. We have one, two wheel straps holding our wheels in, and then we have this frame mount.
What our customers are saying:
"Just to let you know I was very satisfied with my orders for a hitch, wiring harness, bike rack and extension. I have a 1995 Dodge Ram van and some of the parts are hard to get elsewhere. I received all my orders proptly and will recommend you to others. The pricing can't be beat. Thank you. Sincerely, Frank"