Most Popular Motion Detecting for 2016 GMC Sierra 3500

The rear camera works as one would expect. However, the monitor is not as clear as my old Voyager and the build is less then the Voyager. Once the monitor was mounted on the Ram mount I have on the RV dash the monitor started to make a rattle noise which is coming from inside the monitor. Currently doing the research for a better monitor.

Have not been out on the road yet but the install was easy even for a novice like me. My reflection 5th wheel was prewired so it was a plug and play for the rear camera. For the side cameras I used the two screws from the previous light. I put both screws in the top holes, (one behind the camera) as that seemed to secure it better then bothe screws not behind the camera. Instructions were a bit limited(or I didn't read them) on the side camera sync but I pressed enough buttons to figure it out. Picture looks great. Do watch for obstructions such as awning supports which will limit view. I also used silicone to keep the water out.

Click to Enlarge

The rear camera works as one would expect. However, the monitor is not as clear as my old Voyager and the build is less then the Voyager. Once the monitor was mounted on the Ram mount I have on the RV dash the monitor started to make a rattle noise which is coming from inside the monitor. Currently doing the research for a better monitor.

My trailer was prewired for the Furrion camera so it was truly a plug and play install. Haven’t used it yet but everything works as it should.

The rear camera works as one would expect. However, the monitor is not as clear as my old Voyager and the build is less then the Voyager. Once the monitor was mounted on the Ram mount I have on the RV dash the monitor started to make a rattle noise which is coming from inside the monitor. Currently doing the research for a better monitor.

I came with a 5" screen the last on in the kit came with 7" not happy with this order.

The rear camera works as one would expect. However, the monitor is not as clear as my old Voyager and the build is less then the Voyager. Once the monitor was mounted on the Ram mount I have on the RV dash the monitor started to make a rattle noise which is coming from inside the monitor. Currently doing the research for a better monitor.

Have not tested this on the road, so this covers installation. Instructions are clear and easy to follow, I was not clear about what to do with the trigger wire when you are retro fitting to an older RV, the FAQ on etrailer had the info, thanks for that. Installed this on a 2000 Lance camper sitting on a 1978 Ford F250 The side cameras were very easy to install, the backup camera required a little bit on modification to the camper. I did not like the monitor install options so did some simple modifications to the stand so I could use ram-mounts. Final setup is amazing

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge