Summer Starts Here - Save up to 70%
# 1
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/2" Long - 7.5K
Purchased a can of BP Blaster penetrating spray the day after I ordered the parts. I sprayed the weld nuts several times while waiting for the parts to arrive and it seemed to help loosen them up. My order arrived on time and I installed the hitch the next morning. I installed the hitch by myself ( I'm 67 years old), and while I admit that an extra set of hands would have been very helpful, the install was easier than I anticipated. I had all the parts I needed, the instructions were easy to follow and the online video was very helpful. I purchased the hitch in order to tow a trailer with a ton of wood pellets, instead of getting 1/2 a ton at a time (the capacity of my truck). Hopefully these products will solve my problem, only time will tell.
Works great with receiver!
# 2
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
Purchased a can of BP Blaster penetrating spray the day after I ordered the parts. I sprayed the weld nuts several times while waiting for the parts to arrive and it seemed to help loosen them up. My order arrived on time and I installed the hitch the next morning. I installed the hitch by myself ( I'm 67 years old), and while I admit that an extra set of hands would have been very helpful, the install was easier than I anticipated. I had all the parts I needed, the instructions were easy to follow and the online video was very helpful. I purchased the hitch in order to tow a trailer with a ton of wood pellets, instead of getting 1/2 a ton at a time (the capacity of my truck). Hopefully these products will solve my problem, only time will tell.
Works great with receiver!
# 3
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs
Longer stinger let me drop the tailgate on my Tacoma with trailer attached. Replaced a similar but shorter Curt hitch and both are very substantial and well made for the weight of my trailer.
With good information from the website it was easy to order a Curt 2" Trailer Hitch, the Upgraded Circuit Protected Tail Light Converter Hardwire Kit w/ 4-Pole Connector and Circuit Tester - 119178KIT, Curt Ball Mount for 2" Hitches (3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs - D-4), Curt Pin and Clip Hitch Receiver - C21500, Rubber Tube Cover for 2" Trailer Hitch Receivers - I-728,Review, and 2" hitch ball 40038. Parts were delivered earlier than the initial estimate. Self installation (on a sloped drive way) took just under 2 hour. The fit of parts was very good, instructions and on-line video's were very helpful. My Kia did not have the wire plug in option, but the splice connections in the wire kit were easy to install. Most of the parts are hidden from view when the ball mount is not used.
# 4
Curt Ball Mount w/ Sway Control Tab for 2" Hitches - 3/4" Rise, 2" Drop - 7,500 lbs
I cannot use this ball mount because the shaft is too short that goes into hitch receiver on my one ton Dodge truck. It does not allow enough room between truck back bumper and ball to allow any trailer tongue to be put on ball.
# 5
Ball Mount 3/4" Rise or 2" Drop - 12-5/8" Long
This is a great product it did what I needed thanks e trailer
Who it concerns, I needed to purchase a new trailer hitch as one I had rusted and weakened badly. I did shop around, and felt etrailer. com with free shipping included in the total cost was the better value. Received hitch within a reasonable delivery period, and installed the hitch with absolutely no problem, in a very short time, as all nuts and bolts were included with the hitch. I was, and am very well satisfied with all aspects of my purchase from etrailer.com.
# 6
Convert-A-Ball Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10,000 lbs
Makes for a great hard-core dirt road set up with a 3000 pound trailer, in conjunction with the Curt rocker ball, Towing with an F150 over many miles of washboards, down through washes where the road was washed out, etc. Really makes for a gentler set up on the equipment in the trailer and the truck. Thanks a lot E-trailer!
My usage of your hitch is a bit unusual, I think. I pull a two ton roller with my Ram and I've used your cushioned hitch to smooth out the process. The roller Lunette just dropped over a 2" ball and then banged and jerked on the ball neck. Check out the photos for my adaptation.. I can flip it over and use the 2" ball! Have enclosed some photos. The cushion is holding up very well and it takes a beating!! Thanks
# 7
Draw-Tite Ball Mount for 2" Hitch - 7" Rise, 8" Drop - 9-1/2" Long - 12,000 lbs
Heavy Duty Drop Down Hitch no problem pulling a 10,000# trailer
It fits perfect on my f350 diesel, super heavy duty. I'll be using it for towing my car tilt bed trailer.
# 8
MaxxTow Ball Mount w/ 2" Accessory Receiver - 2" Hitches - 2-1/4" Drop - 5,000 lbs
Heavy duty , very good quality.
# 9
MaxxTow Tri-Ball Mount for 2" Hitches - Hollow, Black Powder Coated Shank - Chrome Balls
As advertised
Good quality part. Easy Install. Used for a year so far. No problems.
# 10
Curt Towing Starter Kit for 2" Hitches - 2" Ball - 2" Rise, 4" Drop - 7.5K
Nice combination to go with my front hitch for the F150.
dodge journey 2014 etrailer service excellent the hitch don't fit perfect with the spare tire other ways is pretty good if you tele out the spare tire you going to have a hard time to put them back etrailer sevicio es excelente la pieza no se acopla perfecto con la rueda de repuesto del resto se monta perfecto . si se retira la rueda de repuesto es muy dificil de poner de vuelta en el compartimento
# 11
Draw-Tite Ball Mount for 2" Hitches - 5" Rise, 6" Drop - 10-1/4" Long - 16K
Top Notch!! All as described and fast shipping!!
Its been a year and I aint broke it yet. I use this hitch to tow my 7Klb trailer. The trailer is tongue heavy and I needed something rugged to tow it with. Haven't had any troubles with this hitch.
# 12
Curt Multi-Ball Mount for 2" Hitches - Solid, Black Powder Coated Shank - Black Balls
Weights a ton. Seems very strong...10,000 pounds using the 2 5/16s balls. Good paint.
Functionally, this hitch has been great with no issues to date. Aesthetically, the black color did quickly fade to a gray color within a couple of months. Ball surface also presented rust after very minimal use. That being said, I did buy a hitch to tow trailers, not look pretty.
# 13
Curt Tri-Ball Mount - 3 Chrome Balls - 10,000 lbs
definitely solid as a rock
Excellent product! With the three different ball sizes, this tri-ball mount gives you a lot of flexibility. Gone are the days of having several different ball mounts to fit different tongues. High quality construction makes this an excellent investment.
# 14
Hidden Hitch Ball Mount - 3/4" Rise, 2" Drop - 15-3/4" Long - 6,000 lbs
Ordered this hitch and it worked perfect for what I needed just bought a teardrop trailer. Couldn't open up the tailgate on my Jeep so I ordered this extended hitch and I brought the ball out past my spare tire and the tailgate opens up now I have no problems. And I looked everywhere couldn't find one of this quality and at this price very reasonable the other ones hundreds of dollars didn't want to spend that much.
This was the longest hitch ball mount I could find anywhere. I used it with a short extension for my 2021 T G so that I could open the back doors without hitting the trailer wheel crank. With my new trailer, Intact Flyer Discover, I don't need the extension and can still open the doors. Works well.
# 15
Curt Class III Ball Mount with 2-5/16" Ball - 2" Drop - 7,500 lbs
Who it concerns, I needed to purchase a new trailer hitch as one I had rusted and weakened badly. I did shop around, and felt etrailer. com with free shipping included in the total cost was the better value. Received hitch within a reasonable delivery period, and installed the hitch with absolutely no problem, in a very short time, as all nuts and bolts were included with the hitch. I was, and am very well satisfied with all aspects of my purchase from etrailer.com.
This is a great product it did what I needed thanks e trailer
# 16
Convert-A-Ball Cushioned Multi-Hitch Clevis and Pintle Hook Combo w/ 3 Balls - 2" Hitches - 10K
No problems with the hitch- makes it easy to switch between trailers! I have no complaints!
Works as described. Perfect for light truck use.
# 17
Curt Class III Drawbar - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs
A very solid replacement for the stock Bronco hitch. Fits perfectly.
Product appears to be solid but it’s just a paperweight without a locking pin. Since your tow bar doesn’t come with one either it’s just another piece of metal. Product should include locking pin. No satisfied at all
What our customers are saying:
"Very broad selection and outstanding service."