Yes, it is accurate. The Curt Trailer Hitch item # C13382 is confirmed to fit all models of the 2024 Subaru Crosstrek except for the hybrids. There was a customer that recently installed this on a 2024 with no issues back in May and he sent me in a picture which I have attached below. No modification or customization needed. It went right on his Subaru.
If you are planning on towing you will also need a wiring harness item # C56040 and a ball mount kit item # C45534.
I recommend using... view full answer...
I've attached the dimension pictures you requested for the # 37220BL. Let me know if you would like any other dimensions and I'll get them added in. view full answer...
Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety margin. A tire's rated Load Range means the maximum weight load it can handle (when installed on a suitably-rated wheel) at its full rated PSI pressure.
Trailer tires must always be fully-inflated to their maximum rated pressure as noted on their... view full answer...
The weight of the Draw Tite hitch part # 76209 that you referenced is 33 lbs.
The towing capacities are:
Maximum gross trailer weight: 4,500 lbs
Maximum tongue weight: 675 lbs view full answer...
The Curt Trailer Hitch Receiver # C12136 will fit your 2015 Subaru Outback and allow you to use a Thule bike rack that fits a 1-1/4 inch receiver like the Thule Camber # TH9058.
The distance from the hitch pin hole to the Curt hitch opening is 2 inches, so it is going to be perfect for your Thule bike rack.
I have added a link to a video install for you to check out as well of the Curt Trailer Hitch Receiver # C12136. view full answer...
Yes, they will. To attach the 53" Thule WingBar Evo Crossbars item # TH711420 to the factory rails of your 2022 Subaru Forester Wilderness you will need the Evo Raised Rail Feet for Thule Crossbars item # TH710401.
They're only 3" wider than the 50" Thule WingBar Evo Crossbars item # TH711320 that are recommended for your Subaru. view full answer...
The weight capacity of the Yakima CoreBar Crossbars like part # Y00421 is 220 lbs which is for loads evenly distributed across both bars. If you need a higher weight capacity, Yakima does off the HD Crossbars like part # Y01157 which have a 500 lb weight capacity.
Please note, the feet and or vehicle roof may be rated lower and in which case you would abide by the lowest of the three components whether that be the crossbars, feet, or vehicle. view full answer...
The highest part of the Saris MHS Bike Rack for 1 Bike # SAR23MR when folded is the handle of the Saris MHS Platform Rack Base # SAR38MR.
From the center of the hitch pin hole on your hitch to the top of the Saris MHS Platform Rack Base # SAR38MR is 22". The top of the bike tray would just be a few inches below that height. view full answer...
I would be happy to! Weight distribution systems are selected based off of tongue weight which is typically between 10% - 15% of your trailer's total weight. This would put yours between 250 lbs - 375 lbs. There's really only a couple of systems that work with this low of a tongue weight and you do not want to use an overrated one.
I recommend the Equal-i-zer Weight Distribution System w/ 4-Point Sway Control item # EQ37040ET. This system works with tongue weights up to 400 lbs so you... view full answer...
I have a solution for you but I don't have any options for heat shields to protect your cargo when mounted on the Flint Hill Goods Cargo Carrier item # FHG27ZR. This will be an issue with any cargo carrier or accessory you mount on your Forester so the best option will be to point your exhaust down and away from the rear of your Subaru.
To do this you will want to change out your exhaust tip. You will need to measure the diameter of your exhaust pipe to determine which one you will need.... view full answer...
I believe you are asking about how to find out if you will be able to open the hatch of your 2019 Subaru Outback Touring with the Thule Force XT XL Rooftop Cargo Box # TH6358B installed.
Determining this is very simple; all you need to do is measure from the middle of the front crossbar to the seam between the hatch and the roof. If this measurement is at least 51-1/8 inches you will be able to fully open the hatch of your '19 Outback without any interference. If you take a look at the... view full answer...
The EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2", part # 306-X7601, is 2-1/2" from the face of the hitch receiver to the center of the hitch pin hole. It has a depth from the center of the hitch pin hole to the interior depth of this hitch receiver is 5-5/8". This hitch receiver has a maximum tongue weight of 525 lbs and a gross maximum trailer weight of 3,500 lbs. Please keep in mind you will always use the lowest of these two ratings, your hitch receiver and your... view full answer...
I spoke to my contact at Curt and he sent me a complete dimensional drawing for the Curt Hitch part # C12270 that I attached for you to review. view full answer...
The external measurements of the Thule Canyon roof rack # TH859XT are 50-1/4 inches long by 41 inches wide by 6 inches tall. The internal measurements are 39 inches long by 40 inches wide by 5 inches tall. The usable interior dimensions are 39 inches long by 36 inches wide. You can see these dimensions on the photo I've provided. To see a product demonstration video, click the provided link. view full answer...
There is one electric bike carrier that will deliver all of the characteristics needed for your application, the premium EasyFold Electric Bike carrier from Thule, part # TH903202. This carrier costs more because it is designed and built to be a class-leading product, one that is sold all around the world. Here's why I recommend this rack over all other e-bike carriers.
The EasyFold fits all hitch classes: 1, 2 and 3; it has a 65-lb weight rating for each bike so you have extra capacity... view full answer...
That all depends on what roof rack you have or that you are looking at. The Thule Hullavator Pro # TH898 itself weighs in at 39.7 lbs but that is not including any roof rack parts.
If you could verify which roof rack you have I can let you know the total weight if we carry it. If you don't already have a roof rack just let me know the year/make/model of your vehicle and if you would prefer traditional bars, like square or round, or if you would rather have aero bars and I can make a recommendation... view full answer...
The Thule Apex XT 2 Bike Rack # TH9024XT you were looking at is very easy to remove and reinstall on your 2020 Subaru Forester. To install the rack into your hitch you will place the black hook into the pin hole of your hitch, tighten the anti-rattle knob until the rack is secure, and lock the knob with the provided key.
To remove it you will unlock the lock on the anti-rattle knob, turn the knob counter-clock wise until the black hook in the pin hole can be removed, and then slide the... view full answer...
The Curt Channel Style Adjustable Ballmount # C45900 weighs approximately 30lbs. That includes the receiver pin and cotter pin.
The Rapid Hitch Adjustable, Aluminum Ball Mount Kit # AM3461 is one of our lightest weight adjustable hitches. At only 12lbs the aluminum construction not only makes it light but it will not rust or corrode in salty and wet areas.
The Rapid Hitch Trailer Hitch Lock and Adjustment Pin Lock Set # AM3492 will provide you with a locking pin for the height adjustment... view full answer...
Go To Results