You can use either the Low Profile # ASA56YR or the Standard # ACDOM135B Advent 13.5K AC unit to replace your current Dometic unit. It will work with the digital thermostat, furnace system and air distribution box being ducted in the ceiling.
The only difference in these units is the height. They both have the same cooling power and 500 cubic feet per minute of circulation. If the height is not an issue you can go with the standard unit over the low profile. view full answer...
Hi Cary,
There unfortunately isn't a guide to tell us what door latch your Freelander uses so you'll need to remove the backing plate to your current latch so that you can see the cutout hole in the door and measure it. The # BA64FR requires a 5-1/4" wide x 4-1/2" tall cutout hole.
We also offer the Bauer Products European Style Motorhome Entry Lock # BA58AR, which requires a 7-7/16" tall x 3-3/4" wide cutout hole. view full answer...
Hello Tom,
Thanks for writing in.
Your Dometic 651916C751J0 is part of the Dometic Penguin series, and those systems could be installed as either a ducted or ductless setup depending on how the RV was originally built. Because of that, the best replacement really comes down to how the air is distributed inside your camper now.
If your RV has ceiling vents throughout the coach that distribute air through ductwork, then you will want the ducted Furrion Chill Cube system # FR49TD. This... view full answer...
Hey Donaldo! The JR Products Automatic Changeover 2-Stage Propane Regulator # 37207-30395 uses 1/4" Inverted flare inlet x 3/8" FPT outlet connections. These brass inlet adapters are removable so you could connect your hoses directly.
Any big trips coming up with your Chaparral? view full answer...
Hey Donald,
The battery box # 329-HM426 is a great fit for 2 6v batteries. In terms of it fitting on your trailer that just depends on the room you have to mount it. The actual size of the box is 17-15/16" long x 14-5/16" wide x 14" tall. So as long as you have a spot that it can fit this is going to work great for you.
How often are you able to get out with that trailer? view full answer...
Hey Barry! The Stromberg Carlson RV Exterior Ladder # LA-401BA you were looking at will work with your 2015 Coachmen Encounter 37TZ. This is 99-1/2" tall and can be cut to size so it lines up perfectly on your motorhome. It is also available with a silver finish # LA-401 if that is a better fit for your setup.
Where are you headed next with your Coachmen? view full answer...
Hello Cindy,
We do have the RV Porch Utility Light - Incandescent - Oval - White Housing - Amber Lens # RVPL5A it comes with a 1141 bulb which is not as bright as the 1156 bulb you are used to. The 1141 and the 1156 both have the BA15s base, so you could swap out the bulb to the brighter one.
What kind of camper is this going on? Any big adventures planned for the near future? view full answer...
We sure do Steve and welcome back! The SnapPad TC Jack Pads for HappiJac Camper Jack Feet item # SN67VR are the ones you'll need.
The SnapPad TC Jack Pads item # SN67VR are custom fit for all of the HappiJac systems. This set of four pads measures 7-3/4" long x 7-3/4" wide x 2-3/4" tall. They'll permanently mount to the feet on HappiJac systems like item # LC736514-ELKIT and item # LC736514-4.
What kind of camper do you have and what type of ground do you typically camp on? Feel free... view full answer...
It sure will Steve and congrats on the new truck! The Fastway Flash Force Adjustable 2-Ball Mount item # FA43FR will indeed fit the 2-1/2" receiver on your factory F-250's hitch.
The Fastway Flash Force Adjustable 2-Ball Mount item # FA43FR has a 8,000 lbs towing capacity with the 2" hitch ball and a 18,000 lbs towing capacity with the 2-5/16" one. This ball mount adjusts in 1" increments to give you up to a 4-1/2" drop or rise to ensure your trailer's coupler is level.
We also have... view full answer...
Hey Mike, the good news is that basically all electric a-frame jacks are made the same so any of the ones we carry like the etrailer jack part # e64GV would fit and work great. This is an entry level electric jack that will get the job done but it won't be the fastest or the quietest. On the opposite end of the spectrum we have the Phoenix part # UF38-944040 which is very fast and would raise and lower in just a matter of seconds.
Somewhere in the middle we have the etrailer jack part... view full answer...
Hey Garret, I was not able to verify for sure what pin box model your 2021 Coachmen Chapparal Lite 30bhs has so I can't say for certain at the moment. Can you check the pin box on the trailer now and look for a sticker or tag with the model number on it? With that I can say for certain. The part # GY37ND that you referenced fits the Lippert Rhino in case that's what you have. view full answer...
Hey Keith! Yes, the Kuat Dirtbag Bike Rack # DRT15 is designed for bikes with a 15mm x 100mm front thru-axle, so it's a great fit for your Aventon Level 3. Just make sure you install it on a surface capable of handling the weight from your e-bike.
Where are you planning to mount the Dirtbag? view full answer...
As long as your current tires are 16" and your bolt pattern is 8 on 6-1/2 the # AM20768 will work as a spare. From the videos I found it looks like you do have the 8 on 6-1/2 bolt pattern but nobody focuses in on the wheels and tires so I would double check. You can find your tire size on the side of the tires. view full answer...
Hey Justin, thanks for stopping by! You can use the Dometic RV Water Heater # DMC74FR to replace your Dometic GC6AA-10E water heater.
This water heater is also a 6 gallon unit, like your current one, and requires a 12 3/4" tall x 12 3/4" wide cutout. You will need a bit more depth to get this to fit so you'll want to verify you have the correct amount of space first.
Feel free to come back and let me know if there is anything else I can do for you! view full answer...
Hey Brian,
The only bike rack that can handle your beasts is the Saris MHS DUO Bike Rack for 2 Bikes # SAR73MR. This has a 100 lb per bike weight rating while all of the other options will have a max of 80 lbs per bike. You'll be able to secure the front wheel with the clamp, but you might need to get creative or even remove your rear fenders in order to get the back clamp to fit properly. You will also need to remove the batteries, so you aren't overloading the bike rack, plus it just... view full answer...
Thanks for reaching out Sarah. For something like the Covercraft Work Truck SeatSaver Custom Seat Covers - Front - Tan # SS2422PCTN, the price includes both front seat covers. Keep in mind that these are custom-fit covers designed for specific vehicle applications, so there isn't a reliable way to confirm they'll fit the seats in your motorhome.
The Classic Accessories RV Captain Seat Cover # CA80112 that you were also looking at is designed specifically for RV captain's chairs. It fits... view full answer...
Hey Janus, the size we have listed for your 2024 Coachmen Pursuit 31BH is 28 inch like what the part # CP24ER is designed to fit. We have a similar design in a 32 inch though with the part # CP37WR which uses the J-hook attachment so this would work as well. view full answer...
Hello Terry, thanks for reaching out. Assuming your 2016 Coachmen Freelander Motorhome is on a Ford Chassis (it should be) we do offer an inside windshield cover that will work great. Here is what I recommend:
- WeatherTech Roll Up SunShade Kit - Front and Side Windows - Dual Purpose # WT87QV
This is confirmed to fit the 2016 Ford E350 windshield. It comes with the inside windshield cover as well as covers for the driver and passenger side windows.
What floorplan is your Coachmen Freelander... view full answer...
Hey Ronald.
No, I do not recommend the combination of Reese Sidewinder pinbox and Anderson Ultimate 5th wheel in any configuration, even with the turret locked out. Reese recommends against using any gooseneck to 5th wheel adapter with their Sidewinder as they're not built to sustain the forces applied by a Sidewinder. I recommend picking up the Demco Recon 5th Wheel Trailer Hitch # DM53XV you were looking at. I like the wraparound jaw as this greatly reduces rattle. Plus, this hitch is... view full answer...
Go To Results