We have the perfect rack for carrying your e-bikes with fenders and step through frames! You will want the Thule Easy Fold XT part # TH903202. This rack will fit your 1-1/4 inch hitch, has frame clamps designed for your style of frame, is specifically intended for e-bikes, and comes with ramps to make loading/unloading the heavier bikes (which it is rated for) easier. I attached a picture of the rack carrying a bike just like yours for you to check out as well. view full answer...
Hey Luke!
On the etrailer scissor jacks # e56VV, the closest bolt holes center-to-center are about 3-1/2" apart, while the next set of holes is 4-1/2" center-to-center. Since yours are currently 80mm apart, that translates to a little less than 3-1/2". If it won't fit right over the studs, you could try to wallow out the holes a little to fit, but keep in mind that would go against instructions and you'd be on your own as far as warranty goes etc.
Other option is to just see if you can... view full answer...
According to the owners manual for your 2009 Scion xD it can only be flat towed with all 4 wheels on the ground if you have a manual transmission. You can dolly tow with either an automatic or manual transmission. So a Tow Dolly # RM-2050-1 is likely going to be what you want. If you have a manual transmission and want to tow all 4 wheels on the ground please let me know and I can list the parts you will need. That install is likely going to require you to go to a local shop to have everything... view full answer...
Hey Bugg.
For a 2014 Scion xD with a naked roof you would need the Inno Aero Roof Rack for Naked Roofs # IN62DR. This would include the fit kit to match the contours of your roof, the feet to mount to the fit kit for the crossbars to mount to, and the two crossbars, giving you everything you'll need for a roof rack.
I've attached a short video below where we'll take you through the installation process. view full answer...
The Thule Tepui Low-Pro 2 Rooftop Tent part # TH8001LP204 doesn't come with an annex and there is not one for this. The Yakima SkyRise HD Tent for Roof Rack Crossbars part # Y07436 doesn't come with an annex either but there is an option to add one using the Annex for 2 Person Yakima SkyRise Tents part # Y07421. I have a rooftop tent myself (Thule Tepui Kukenam) and did not get the annex as I didn't see the extra coverage being worth the added cost. That said, I also have a larger truck... view full answer...
The only hitch that fit your 2008 Scion xD is the Curt Trailer Hitch Receiver 11491 but that was discontinued back in 2020. (your photo didn't come through but I understand what type of hitch you're wanting)
With that being the case, we still have some alternatives for transporting a bike with your vehicle; with a trunk mount or roof mount bike rack.
A trunk mount rack, like the Thule Passage # TH910XT, is more cost-effective but it means you can't open up your rear hatch while it's installed... view full answer...
When Curt did the test fittings, they saw that it would be fairly difficult to modify the panel so it would fit around the hitch. Therefore, they haven't tested how to trim the panel.
The purpose of the underbody panel is to smooth and direct the airflow passing under the car while it's moving down the road, reducing some turbulence.
Leaving the panel off will not harm anything, although leaving the panel off might have a very small negative effect on the aerodynamics of the vehicle.
The... view full answer...
For your 2012 Scion XD, the Blue Ox Base Plate Kit - Removable Arms # BX3778 is a confirmed fit that will require some trimming of the fascia. I've attached the installation instructions to assist. The Blue Ox Alpha 2 Tow Bar - Motorhome Mount - 6,500 lbs # BX7380 will be a great fit for your vehicle and these base plates. This comes with the safety cables you need.
For your wiring, I recommend the Roadmaster Tail Light Wiring Kit w/ 7-Way to 6-Wire Connector - LED Bulb and Socket -... view full answer...
For your 2013 Scion xD both of the clips you mentioned are needed to install the Yakima roof rack but they have been discontinued by the manufacturer.
My recommendation for you is to use the roof rack consisting of the following:
Vortex aero crossbars # RRVA118B-2
Feet # RRRLKVA
Custom fit kit # DK060
This roof rack is great quality for the cost compared to other brands. It will also include the locks needed to secure your investment. view full answer...
The trailer hitch receiver we have available for your 2013 Scion xD is the Curt Class I # C11134. This is compatible with LED or without LED taillights on your vehicle. This hitch has a tongue weight capacity of 200 lbs max, but you will want to make sure your vehicle can handle that weight by checking your owners manual. This hitch does require the Curt Trailer Hitch Support Strap - Bike Rack Strap with Cambuckle # 18050 for non-trailer accessories.
The Bruno ASL-250 is 98 lbs, so... view full answer...
We do have a trailer hitch that will fit your 2012 Scion xD, but the Draw-Tite Sportframe Trailer Hitch # 24828 is not a compatible fit.
I recommend the Curt Trailer Hitch # C11134 which is custom made for your vehicle. This receiver is a Class I 1-1/4 inch trailer hitch with a weight capacity of 2000 lbs and a tongue weight of 200 lbs. It features bolt-on installation with no welding required. I have included a link to the installation instructions as well.
The recommended ball mount... view full answer...
Your Scion xD will work with several Thule trunk-mount 2-bike carriers including the Passage # TH910XT. The link for trunk-mount carriers provided will show you all four carriers suitable for the 2008 through 2013 Scion xD, which include the Passage, Gateway, Archway and Raceway series. Please note that for any of these carries the rear wiper on your Scion cannot be used with the rack in place, and the plastic cover over the rear bumper may deform from the weight of the bikes. (It is recommended... view full answer...
After consulting my source at Roadmaster, I found that for the installation of the RoadMaster EZ Base Plate Kit # 521181-5 for your 2012 Scion xD, trimming of the spoiler, air dam, grille, or plastic fascia may be required and trimming of the lower air dam, air deflector, cowling and/or rock guard is required.
The instructions for proper installation of # 521181-5 are linked. They are very detailed and show all the modifications that are required on your 2012 Scion xD.
If you are looking... view full answer...
You can get the Replacement Control Key # Y8007835 for Yakima Same Key System that is used on your roof rack. This will allow you to remove the cylinder Core # Y8771-A146 which will allow you to find the correct replacement Key # Y8772-A146. I used the Core # Y8771-A146 and Key # Y8772-A146 as examples, once you have located the key code on the side of the cylinder I can help you find the correct key for your cylinder. view full answer...
The windshield wiper blade lengths specified for your 2008 Scion xD are different for the driver-side and passenger-side wipers. This is not unusual. Neither takes the 19-inch size you mentioned. However, we do have blades that are a confirmed fit for your Scion.
Our most popular blades that fit your 2008 Scion xD consists of 26-inch blade # SC59FR Scrubblade Platinum Windshield Wiper Blade for the driver-side and 14-inch blade # SC89FR for the passenger-side.
These meet or exceed the... view full answer...
For the 2013 Scion xD only a smaller light-duty 1-1/4-inch hitch is offered. This is because this vehicle's frame cannot handle more than a Class I hitch's 200-lbs tongue weight (downward force from the scooter ramp's weight).
Although hitch adapters like # HTAD exist, and these can allow installing a 2-inch accessory item into a 1-1/4-inch hitch, all such adapters cause you to lose half of your hitch capacity because the actual weight load is further away from the hitch. This greater... view full answer...
Yes, the Roadmaster EZ Base Plate Kit # 521181-5 for your 2008 Scion xD is compatible with the Roadmaster StowMaster Tow Bar # RM-501.
For a complete flat towing setup you will need a base plate kit, tow bar, safety cables, vehicle tow bar wiring, a supplemental braking system, and possibly a high-low adapter. If you do not have all of these components then I recommend picking up the following:
EZ Base Plate Kit - # 521181-5
StowMaster Tow Bar - # RM-501
Safety Cables - # RM-643
Wiring... view full answer...
While I can's speak for Towmaster because we do not carry any of their products, when you are using the Roadmaster Tow Dolly with Electric Brakes # RM-2050-1 or Roadmaster Tow Dolly with Self-Steering Wheels and Electric Brakes RM-2000-1 (Discontinued), according to the owners manual you need to put your 2014 Scion xD in neutral before towing it on a dolly. view full answer...
A 2 inch ball mount cannot fit directly into the opening of the Curt hitch part # C11134 that you mentioned but a 2 inch hitch ball could if that's what you meant. We have the Euro ball mount part # C45572 which is a fit for this hitch that has a 2 inch ball. view full answer...
Yes, the Thule Gateway Pro trunk mount bike rack # TH88VR, will fit your 2008 Scion xD. I have included a link to a video review of this bike rack for you.
If you will be carrying any bikes that do not have a top frame bar that goes straight across (like a typical men's bike would) then I recommend using bike adapter bar # TH982XT. This will allow you to carry those bikes more level and will provide better ground clearance. I have to use these adapters and without them my wifes bike would... view full answer...
Go To Results