Need a light that makes your trailer easy to see without adding bulk? This slim 20.5" x 1" TecNiq LED delivers strong red and white illumination from 14 LEDs packed into a sleek housing. It handles stop, tail, turn, and reverse functions with clarity that stands out day or night. The clear lens keeps it looking sharp while boosting visibility for safer travel.
Dust, rain, or road spray won’t slow this light down. It’s IP68 rated for complete dust and water protection, so it keeps working even in tough conditions. The housing and circuit board are sealed to prevent moisture from getting in, making it equally at home on the road or near the water.
The durable lens takes on vibration and impact without cracking or fading. Inside, the circuit board is protected against shock and weather exposure to keep the LEDs running strong for the long term. TecNiq backs that reliability with a lifetime warranty, so you can count on it every time you hook up.
Installation stays easy thanks to its slim profile and surface-mount setup. Whether you mount it vertically or horizontally, you get a clean fit that doesn’t stick out or require deep recessing. The 6.5" unsheathed pigtail makes wiring straightforward on a 9–12V DC system—no complicated adapters or brackets needed.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steve here with etrailer.com. Let's take a look at our TecNiq Slim Profile Stop Tail Turn and Reverse Light. It measures technically 20 and one half inches overall, but it's considered a 20 inch clear lens. Now this is powered by 14 LEDs. As I mentioned, it's technically 20 and one half inches overall.
And center to center on the magnet holes, I got 19 and one half inches center to center. There's no hardware included. You would've to source that locally. Now, as you can see, I've got it lit up here just for basically running lights. I'm gonna go ahead and shut off my overhead lights so we can take a look at the other options.
So obviously, we're gonna have our brake lights. So you can see it's gonna light up brighter. And it does have a guaranteed circuit board protection built in here, along with the durable impact resistant lens. And the reverse light. Now this, again, is 20 and one half inches long, one inch tall, one half inch deep.
Let's go through the brake lights far away now. And then obviously, if you had it wired up for turn signals, you can make it flash accordingly. So there are four wires coming off the backside of this light, and that pig tail is six and a half inches long. And there's a better view of that. So you have white, black, red, and yellow.
And like I said, everything here is sealed up so you don't have to worry about dust, water, or anything like that. You can mount it either vertical or horizontal, or even at an angle if you so choose depending on your setup. Runs on 12 volts. Again, there's 14 individual LEDs in there with a clear lens. This is the TecNiq Slim Profile Stop Tail Turn Reverse Light. I'm Steven. Thanks for watching.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.