Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replacing a cracked or discolored skylight garnish means you need a proper fit without guesswork. This inner garnish fits standard 14" x 30" cutouts and diffuses harsh light, giving your ceiling a finished look and softer light inside.
Finding a replacement that lines up with an existing cutout can stall a repair, especially when exact specs are unclear. This garnish is built for a 14" x 30" cutout with a 16" x 32" flange, so it aligns with common opening sizes and provides full interior coverage. You can focus on matching the opening instead of chasing exact model specs.
After removing a skylight, exposed foam and wood around the opening can leave the interior looking unfinished. This garnish installs on the inside to cover those rough edges and sits flush against the ceiling. The result is a clean, finished look instead of visible construction materials.
Interior trim that sits too high can interfere with the skylight above or reduce usable space. With an approximate 4" bubble height, this garnish is shaped to nest without contacting the skylight when measurements are verified. You keep the intended clearance without unwanted contact points.
Direct light through a skylight can create glare and uneven brightness inside. The white polycarbonate construction diffuses incoming light as it passes through the garnish. This creates a more even light spread instead of harsh direct exposure.
Missing hardware during installation can slow things down if you're not prepared. This garnish installs using 1" screws, which are not included, and some people add butyl tape (sold separately) inside the flange. That tape can help block water from getting inside, while others skip it so any skylight leak shows up right away instead of being hidden. Having your materials ready and knowing how you want to seal it avoids delays once you start.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steven here with etrailer.com. Today we're looking together at our Specialty Recreation Inner Garnish for your RV skylights, measuring 14 by 30 inch on a cutout in white. So folks, like I said, it's gonna be fitting a 14 by 30 inch cutout, but this is sized with a 16 by 32 inch flange, obviously for overlapping and whatnot, and giving you room to install. So very, very high quality. No warping nor lifting.
As you can see, it pops right back out. It's about a five inch height on the bubble itself, and that could vary slightly, due to just how they mold 'em in the mold and those kind of things. You will need some small screws to install this. Those are not included. You can pick them up separately here in another kit.
Or if you have some screws locally, you can use those as well. So again, white polycarbonate. It's gonna diffuse light for a nice, comfortable interior. And again, this would pair with an outer garnish or outer cover, sold separately if you don't already have that. And we do carry these in different sizes.
So if you're not sure on your cutout, how to measure those kind of things, reach out to us, either by chat, email, or phone. We'll be more than happy to assist you as needed. I'm Steven, thanks for watching.
Customer Satisfaction Score:
94% were satisfied with this product
6% of customers were not satisfied
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Christopher H.
9/17/2026
Glad we were able to help Susan! Thanks for including the photo. Please let us know if you need anything else.