Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This custom fit kit lets you mount 4 Rhino-Rack 2500 legs to your vehicle with a naked roof. Clamps mount to legs with bolts. Includes 4 clamps and 4 pads.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today on our 2012 Jeep Grand Cherokee we'll be test fitting the Rhino-Rack 2500 Series Roof Rack with Euro Square Crossbars, part numbers ds1375b and dk234. Now to begin our test fit we've already gone ahead pre-assembled our crossbars and Fit Kit. The Fit Kit came with four rubber pads and four clamps. The bars also do come with the feet. The plastic pad for the foot can be attached to the foot in either direction indicated by the arrow.The instructions found in the Fit Kit do indicate which position the arrow will point. We'll now go ahead and attach the rubber foot from the Fit Kit to the plastic pad on our foot.
We can then undo the Allen bolt insert our clamp, reinsert the Allen bolt holding it in position. We're going to go ahead and leave these loose as this is how we'll clamp it to the vehicle.Each foot has an Allen bolt underneath here on the bar which will secure the foot to the bar. We followed the instructions placing our feet in the correct position on the bars. We'll now place the front crossbar on top of the roof and make sure that we do a measurement here which Rhino-Rack provides from the edge of the front door forward. This will be the location of the rear edge of our crossbar foot.
We'll do this on both sides of the vehicle to ensure that the crossbar's perpendicular with the vehicle.We can then use the included Allen tool to tighten down the two Allen bolts working our way back and forth to make sure that it stays centered on the vehicle. The only thing we have left to do is install the covers. We can then use the keys supplied with the bars to lock the covers in securing our crossbars to the vehicle. Once we have our front crossbar on we're ready to put on the rear crossbar.It's again assembled according to the instructions found within the Fit Kit. Now with our rear crossbar on top of the roof we'll again take another measurement.
This measurement is also provided by Rhino-Rack which will be from the center of the front crossbar to the center of the rear crossbar. This is the location of our rear crossbar. We'll make sure that the clamps go down into the door opening where we can then tighten down the Allen bolt working our way back and forth evenly to make sure that our rear crossbar is secure.Now that we have both crossbars on our roof rack systems secured and we're ready to load our accessories. That completes our test fit of the Rhino-Rack 2500 Series Roof Rack with the Euro Square Crossbars using part numbers ds1375b and dk234 on our 2012 Jeep Grand Cherokee.
Ratings & Reviews
This kit I ordered worked very well when I mounted my Rhino Roof Rack to my truck. It's as close as a perfect fit as you can get! I feel it's secure enough that it will go no where and my rods are safe and secure in my truck!
I couldn't find a rack to fit my car anywhere, I have been looking for years and just found Rhino rack on the Internet a few weeks ago.
The Rhino rack for my Toyota Camry is perfect! Easy to assemble, good quality parts, fits really well. Can't wait to get my canoe out on a lake thanks finally to this rack!!
Great fit kit for our 2013 Prius C. It took us several hours to figure out how to install because apparently we both didn’t read the instructions as good as we thought. My recommendation is READ the instructions first, don’t try to figure it out like we did. Once we thoroughly read the instructions the installation had no issues. We did watch a YouTube video so when we finally found the measurements we were only off an inch. We are happy to be able to have more room on our cross country road this July. The racks are quality and the fit kit easy. The cost is a little high for what you get but that’s on rhino rack not etrailer. We are very happy with our purchase. I will adjust my review later on if anything changes.
Hi George from etrailer,
The rack is awesome! Strong, firm hold and nice looking. When doing surveys, I put my ladders on the rack.
I highly recommend this etrailer.
I'm very happy that Rhino Rack builds roof racks to accommodate a large variety of vehicles. Trying to fit a rack to my 22-year-old Chevy pickup with a naked roof was a challenge. Fortunately, the people at etrailer are extremely knowledgeable and were able to get a direct fit. The rack fits awesome and will help in an upcoming road trip. Thanks Alex and etrailer team.
Fits well. Using RhinoRack system for ladders. Residential Light Construction. I made my own air deflector.lol
Easy install..specs sheet was spot on
Great service. Great delivery time
Everything was good
Still need to put it on the car, but the quality looks great and it was here FAST!
Muy bueno
Fit my 2019 Jeep Grand Cherokee with the appropriate other feet and bars that the site listed. Install took about 2 hours total. The 'VA' measurement for feet position was about 9mm total off from a perfect fit, so I re-positioned them and it fit snug and looks GREAT. Hoping to get some use out of the rack soon.
Awesome product! Fits like a glove on my 2021 Jeep Grand Cherokee Limited X. There is a slight whistling noise, but otherwise couldn’t be happier with the overall package!
This kit adapts the crossbar legs to my Jeep Grand Cherokee. Top quality parts, excellent fit with clear, easy to follow instructions. Measurements are included in this kit for ideal roof placement of the legs.
Bought this rack for my jeep grand Cherokee seems like it would have been a great product.. however the instructions was so unclear, I soon realized I made a mistake buying this product. I was able to install it though I don’t believe it’s 100% correct. If my kayak falls off I’m gonna cry. If you’re thinking about buying this , DONT !
The initial plan was to put them on only when needed.
Now being familiar with their custom fit and performance,They are on permanently. Racks on a Lexus? Who knew!
The product is great! I use it for skiing. Once you get the unit installed
it is snap to take off and reinstall. The only two issues that I have is
on occasion the wind generates a noise as it hits the rack. Usually this
happens around 65 mph. The other issue is I did not like the price. I am
familiar with what goes into making products. The rack should have not
cost more that $500. The company that makes it knows they can get that price
because people love their recreation.
Rick
1/27/2025
Works great quality product but you pay for it.
Jerred H.
1/27/2025
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Jenny N.
4/13/2024
I definitely want to make sure it installs correctly for you. Would you able to send a picture of how it is installed? Can you confirm the type of roof that you have? Do you have flush mounted rails? Do they they have a metal strip that is on top of the rails? Or do you have a naked roof?