Most Popular Backup Camera for 2022 Keystone Springdale Travel Trailer

THe camera was easy to install, pair and use. However, we got very inconsistent results while traveling. The camera would routinely disconnect from the receiver, search for a connection, reconnect, then disconnect once again. Having a rear camera on which you cannot depend is worse than having no camera at all.

Installation was a snap, works as it should. Installed on 2022 Coachmen Freedom Express 274RKS.

The field of view is huge!! Install was quick and easy..definitely 5 stars. I haven’t pulled the camper yet to see if their is a video lag time. I always expect a little..but so far very happy.

While the advertising for a promotion of two extra cameras were on the site, When I applied, it said it wasn't eligible. WARNING, do not buy if you are expecting to get two sidelight cameras. Camera came with packing only on top. USPS can be rough so normal procedure is packing on bottom and top. camera itself works. It is a hassle in the F-150 to run the power all the way back to the rear seat area to get a cigarette lighter power. I'm sure the USB's are just not enough power.

Easy to install and pair. Theres a delay between camera and monitor !!!! The screen is way too small to have the 3 camera displayed. Not really easy to switch cameras while backing up. Would I recommend ti's product, for sure not !

Great customer satisfaction

We purchased this camera to help get our rv in and out of a tight storage spot and to see behind the trailer while driving. The tow vehicle is much narrower than the trailer making it impossible to see behind the trailer even with extended side mirrors. This system allowed me to avoid cutting off any vehicles approaching from behind when changing lanes. The display was installed on top of the dash. The camera replaced the built in furion mount on the trailer. Due to short time, the cord was run externally. This kit is meant for a motorized rv, not a trailer. After opening the kit I realized I had to buy an extension cord to run from the display adapter cable to the rear of the tow vehicle. Then the cable could be disconnected at the trailer hitch. When using the system, the display is good, but very narrow field of view, vertically. So I can either see traffic or see the rear of the trailer for backing up. A second camera would seem to be the best solution but not my favorite one. The mic and audio did not work well. I could not hear my wife, but hilariously, I could hear cars at the rear. Might just be me ... I only ever used channel 2 which I thought was the only channel carrying audio. HINT: adjusting the volume was extremely painful until my wife figured out to adjust it on another unused channel. The brightness could not be adjusted making it bright at night. I aimed the display downwards to help. The instructions seem sufficient and are very brief. The system operates like a prototype rather than a finished model. But it does show the camera even with the display on the dash in the hot sun. We used it for the entire 3300 mile trip. It was on the entire time we were driving. I removed the display after returning home with my fingers, no tools. Overall, I am ok with the system. I still think it was the best purchase for me considering the cost of other systems and the wireless connection problems of other systems except perhaps for the most expensive. Note, I read someplace that some states may not allow a display to be on where the driver can see it while driving.

Ez to install—plug and play. Complete wired system—much more dependable than wireless and a lot less fussy to use. I cable tied the wires under a 37’ Class A. Plenty of wire. Used the old wire as fish tape. Old system was 17 years old. Compared to that, this one is high tech but reasonably priced. The flat screen is lightweight and it was EZ to cut the dash to fit. Very happy with this backup camera. Good clarity. In reverse, grid lines appear. It’s good. BTW The pics of the monitor on the box is the old monitor which is huge and heavy compared to this flat screen.

Relatively easy to install and very easy to use.

The camera and monitor worked good on a 600 mile round trip journey. Took a few minutes to get used to looking generally down on a trailer in tow but that did t take long and was able to back it into place. Setup was easy and it paired fast. Etrailer services is always over the top and their prices are lowest.

Replaced my Airstream older camera with a newer version about a year ago. The wireless camera behaves better, and the monitor is bigger than the older version. Clarity is very good. Have noticed sometimes (like at night while raining), the color disappears, and it is just black and white. Not sure if an adjustment is needed to correct that.

After discussing my needs, etrailer suggested this unit and it is the perfect solution! It's very well constructed metal, rather than cheap plastic. Setup of the monitor was VERY easy with a step by step guide built in. The camera, on the other hand, did not have very clear instructions, but was easy to install. The camera can be powered by the reverse lights, the running lights or (in my case) powered directly to 12v (I used a 12v power outlet so I can unplug it). I have had people tail gate me in the "no zone" and then pass suddenly. I Don't have towing mirrors. It took a while to find the ideal spot for the monitor (I have a midsize pickup), but it fit perfectly to the left of the interior rear view mirror.

I had forgotten my account info and called customer service. They were fantastic. Was able to retrieve my business account and complete the order with no other issues. Thank You customer service for being very polite and patient with me.

Very clear image.

I installed this on my Airstream Bambi just above the license plate. Removed license plate light to expose light power wires. Drilled a large hole to fit the rubber grommet using a step drill, then drilled two small mounting screw holes using bracket as hole drill template. Fed the assembled camera connector through the large hole and pulled the camera connector wires out the license plate light wire hole. Solder camera connector wires to license plate light wires (confirm polarity) and stuffed all wires back into hole. Installed grommet and camera bracket sandwiching the grommet between the back of the camera bracket and trailer siding for a water proof seal. Camera paired first try. Be sure to power only the monitor on first, wait for screen prompt, then turn on camera using trailer lights. Camera image is crystal clear and I've not noticed any image lag. It's been great so far.

Purchased this a year ago to mount on the rear of a camper trailer (after I backed over a mailbox that I could not see). I’m very happy with the purchase. It has been extremely useful when backing the camper by myself. The camera was not too hard to mount, the view is decent, and it has proven to be reliable. Overall, I’m very pleased with the purchase and performance of this camera. I recommend it!