Most Popular Snowmobile Trailer for 2015 Subaru XV Crosstrek

All parts fit my rebuild of new springs for my 1999 Bear trailer that my G3 Bassboat sat on for 26 yrs(used a lot for fishing on weekends)

Direct replacement, good quality

I have received significant support from e-trailer over the past 10 days as I have made several purchases for a new axle, springs, and hangars for my utility trailer. William and others have went out of their way to assist. I have been very satisfied with all products received. I will post another review when the trailer is completed.

Good kit with the necessary parts to replace leaf spring suspension. I welded the hangers rather than bolting them. The parts are not coated for the price point so you will need to paint them or they will rust immediately.

Fit around axle is good but bolts could stand to be at least an inch longer, only tighten up flush with plate under my 5 leaf springs, could not use lock washers had to use red Loctite.

Just mounted my 1.5 inch square axle today using this item. Worked great. I used a cradle to align my axle on the slipper springs (no holes needed i. axle) but the cradle added about 1/4 inch. This means there were no extra bolt threads extending beyond the nut. The lock washers were fully compressed, though. The red on the bolt threads in the pic is just grease.

Perfect component for my 2000# undercarriage project. Very sturdy and fit as advertised.

My 6' x 10' landscape trailer was a homemade by a prior owner. While it was mostly constructed very well, the spring hangers were not correct. The spacing for the springs was also wrong, and it had very little fender clearance. There was also evidence that the spring U-bolts had contacted the frame on occasion. (I do not carry loads anywhere near the 3500# axle rating.) I added an extra set of holes on the front hangers in case the ride height proved to be too much, but I like the way it sits with the stock holes. I don't think I'll be utilizing the extra holes. This kit was just the ticket to increase the suspension travel and fender clearance on my landscape trailer. Now it "sits right"!

These nests are kind of hard to get wrong really. I welded them into position, haven’t thought about them since. So,… I mean,… that’s good right?

I havent really gotten a chance to use the trailer much since my purchase of the leaf springs. But they went on perfect and the stance is perfect. With a weight load , they should be just right.

The galvanized coating is probably a little thick as all but one of the bolt holes are too tight for the bolt to go through it. I will drill them out with a 9/16" and they should be fine.

Excellent product and service.

Great job excellent customer service

Product was as expected and worked well for my project.

Easy to install torqued to 60ft/lb

product was right and just like factory ones on my trailer. just jack up axle to get weight off springs and undo 4 nuts and remove old plate and install new one. fit perfect.