Most Popular Locks Not Included for 2014 Toyota Tacoma

Velo Gripper Bike Rack install was super easy. Velo Gripper installed exactly as advertised. The videos were very informative and install was exactly as described. Install on 2023 Tacoma and it fit perfectly. Bike looks extremely stable so I don’t anticipate any issues.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Holds my bike onto the C-channel of my Tacoma w/o issue. Will likely add some padding under the l-brackets to prevent rattling at highway speed.

It works great. I love that the bikes are secure on a platform opposed to being suspended. It is much easier to load and secure the bikes than it is with the traditional type of carrier. It is a breeze to put the carrier on and off the truck and the bikes do not rub the vehicle.

Great product. Prompt delivery. Easy assembly. Carried 2 heavy fat tire type bykes on turnpike and local roads with no problems. Nice match to my 2014 TRD Tacoma. Glad I found e-trailer. I will purchase again.

This product was a little tricky to figure out at first, I have a 2018 Tacoma and I had to let the tailgate half way down to get the straps through. After I figured that out, it was easy to use and protected my tailgate. Great product! We've loaded three bikes on it at one time (26.5", 27", 29") and it worked great.

Just installed and fits well. Have not used it but tried putting bike on and fit well

The good: I like the way the bikes are held in and the ability to add the upright adapters to the bike frame holders. The straps are quality too. For a jeep with a spare tire, this is the perfect length to clear it. This rack is 5 stars from the bike holders to the base of it. The bad: the 2"receiver adapter and bolt are insufficient. I wish they made this in a solid 2" hitch. The entire setup is held into the receiver by a very short bolt. It only goes about half way into the receiver tube. So your hitch is only "secured" on one side. A hitch pin or bolt should go through the receiver tube completely imo so it can be secured on the other end with a retaining clip or nut. Because this only goes in the one side, the entire weight of the rack plus bikes are held tight to one side of the receiver by the undersized bolt and washer. A few bumps down the road and that bolt loosens. Now instead of distibuting the weight of the rack and bikes on the receiver and post, it's completely up to the bolt to keep you from losing the rack. The bolt threads get damaged too. I took this down a dirt road and nearly lost everything. I had to buy my own bolt with hd fender washers and lock washers to correct this. Thule should've provided this from the start. The current short bolt design where only one side of the receiver secures the rack is unacceptable. This rack is 1 star at best for the connection to the receiver.

Click to Enlarge

I bought this bike rack back in April but wanted to make sure I used it to give the best review. First I want to say I did a lot of research on bike racks and found this one to be the best one to fit my needs. The best price I found was on etrailer.com, at the time it was When I called the customer service to place my order, I spoke to Dan. He was very pleasant on the phone and took the time and listened to what I needed and understood my concerns. I ordered the bike rack and also ordered the Thule Snug Tite Hitch Lock and Anti-Rattle Device and the Thule Cable Lock w/ One Key System Lock. Dan suggested I also get the Thule Bike Adapter Bar, which I never even thought of getting. Delivery was in about two business days, which was really fast and at the time of order they were running a special free delivery over $99. When I went to put it together I noticed I was missing the flat cap screw M6 x 16mm, part number #853-5787-02. I emailed Dan and within 24 hours received an email that the part was sent out and also in the email their was a link to track the order. After I received the part I did notice that the flat cap screw was actually in the 2 inch adaptor sleeve. The instructions were very easy to read, and it took me about 20 minutes to put together. I did have an issue when I positioned the stinger into the cradle, with the 8mm locking nut, it was not staying tight and when I took it off I noticed the threads inside were gone, so I ended up going out to Lowes and buying a new one and its holds perfectly fine. I also had a question about that part because it is not a locking part and was worried someone would try to steal the rack. I contacted etrailer.com to find if they make a locking device for this and they said no but I can contact Thule to double check, I'm still waiting for an answer back from Thule. The weather finally broke and we installed the rack onto my hitch, tightened it and it doesn't rattle. When I finally used the rack and put my bike on, it did sway a little but at 50 mph I was very happy with it. The trailer comes out just enough away from my car that I do not have to fold completely out and I can open my trunk with no issues. I am very happy with my purchase and had a great customer experience with Dan. Would highly recommend ordering from them to anyone.

Click to Enlarge

Click to Enlarge

We got the XTC2 to replace an old school rack. It was easy to put together and feels sturdy and well made. We will be using it on a 2016 Civic, 1999 4x4 Tacoma and a Casita Trailer. Looking forward to using it when the weather warms up.

Click to Enlarge

Click to Enlarge

Looks like a good bike rack. I had to get a front receiver hitch and this bike rack so we could take our bikes when we tow our a-frame trailer. The bikes don’t block our view of the road much if the seats are removed.

Click to Enlarge

Click to Enlarge

I was looking for bike rack product for my Toyota Tacoma. Haveing a cap installed opened the more secure option of racking inside the cap and under lock and key. The fixture is well machined and works great. Finding and ordering was a breeze

I looked at so many products, but then saw these pull up on a truck beside me one day. I started with two and mounted them to the rails in my Tacoma truck bed. After continuous use hauling our bikes to and from triathlons, I bought a third! I can now fit three road bikes across the bed of my truck and still have rooms for gear below them. Thanks of the great product guys.

Click to Enlarge

Click to Enlarge

Works great! It would be nice is it came with the mounting hardware, however. eTrailer.com shipped the product immediately.

Have used the block head bike mounts by Yakima on trips of 800 to 1500 miles with no incident. Easy to mount the bikes and they have not released even on bumpy roads. Great product for my truck box and bikes are always in view. Easiest way I have found to transport our bikes

After one year still love this product! Use it in a 2019 Tacoma Short bed with a leer cover. My bike fits perfectly and is stabilized during travel - so easy to take in and out. Also use the wheel holder which works well. When not using the Sari track its so simple to take out of truck and store.

Excellent product and well made. Looks great

I just received the 2-bike Rhino Rack for use with a 2016 Tacoma, It was easy to assemble and all the accessories for assembly were enclosed. I purchased this rack because it looked like it was very solid and well built. I think this is a very good bike rack. Please note that the Tacoma tail gate will open when the rack is angled down.

The unit ‘s simplicity is a real plus. It takes less than 3 minutes to put the rack on the vehicle. It is well built and very durable and has a nice feature that allows you to open the rear hatch for SUV owners without removing the rack.