# 1
35 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 42" Ground
Replaced the wiring and lights on my 1992 boat trailer. I was able to get everything needed from etrailer. I think Optronics is of the highest quality and recommend both etrailer and Optronics product.
# 2
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
product from Pollak is always great but they packed it with steel couplers and destroyed it
It is a direct OEM replacement, easy installation. What I liked most was a real person answered my call and took my order, Katherine was very polite and knowledgeable. Thanks again. CJ
# 3
Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Vehicle End
My electrical connection to my trailor works very well with this connector.
Used on my Ford to try to keep from replacing my factory harness. Hope it last for awhile.
# 4
Pollak 6-Pole, Round Pin, Plastic Trailer Wiring Socket w/ Rubber Boot - Vehicle End
Used on tow vehicle for hooking up wiring harness to motorhome
This part is an exact replacement to the part that failed. The failure was caused by a poor installation which allowed the rubber boot to chaff on the truck frame. As it was an exact replacement installation was straight forward although I modified the mounting bracket to prevent a reoccurrence of the problem.
# 5
7-Way Molded Trailer Wire Connector, 4' Long
Worked great for my application. The wire colors for 7 way plugs aren't universal so I had to pull up a pinout of a 7 way plug and ohm out the wires to the plug to confirm what went where. But the quality of the plug is excellent. After a year of use on a salt water boat trailer it works great. Just makes sure you heat shrink your butt splices and a little dielectric grease in the plug goes a long way.
When I ordered this harness I thought I was getting a standard 7 way for a conventional trailer with brakes. What I actually got was a harness made for a camper/RV hook up. The wires have all the colors you would expect but all the lights/turn signals are coded into the plug completely different. After spending a good deal of time carefully matching, soldering and heat shrinking all connections to my new trailer harness, I was very dismayed to find only the brakes actually worked. After a bit of research I found a schematics page on the etrailer site and discovered the problem. As this is a molded plug I could not take it apart and just reposition the wires inside the plug. Another full hour or more of rewiring followed and now all is well. The harness itself is of very good quality but was not labeled/identified properly. This could have been prevented if etrailer would clearly label this harness as a camper/RV harness only.
# 6
Hopkins Endurance Multi-Tow 7-, 5- and 4-Way Flat Trailer Connector - Vehicle End - Ergonomic Design
I received the product quickly and in perfect condition the packing was excellant. I installed the connector easily and quickly. I consulted the Gm wiring diagram and als found the wires for all the 7 connections. I had a tight spot within the bumper edge, but managed to find short bolts to attach the bracket in old exsisting holes. The rest was easy attaching the connectors and making sure all wires were through the rear enclosure and tightening them down. I tested the 4 wire connector with my boat trailer lights and it worked like it was designed to do. I LOVE the versatility of this connector. Thanks etrailer.com!! Great product at a great price.
Very well made, nicely designed. Note, if you mount this vertically, as suggested, a plastic cover is provided for the rear, and the unit may extend beyond your old bracket. My old bracket was a part of the original Hidden Hitch, and this extended beyond the old bracket. Because the rear plastic cover is NOT waterproof, it can be sealed with a small bead of RTV or similar sealant under the edge of the cover.
# 7
Quick Fix (TM) 4 Pole Flat Car and Trailer Ends
Product was as advertised and I received them quickly.
I have used etrailer probably four or five times now and have been very happy. Shipping is fast, prices are reasonable and the products are of good quality. I purchased more of the Quick Fix 4 Pole Trailer Ends - they work really well for the non-automotive industrial control project I am working on.
# 8
RoadMaster 6-Wire Connectors - Trailer and Vehicle Ends
Product met my expections and was delivered in a timely manner
This was easy to install looks great and works excellent. have had on issues with this product my trailer lights are always working and keeping me safe.
# 9
Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
Sooo, bought another one to match my truck side connection as GM uses Pollak, which are known to not play well with other brands. The design is just a wire clamp to wire it, which I did with the first one, but trying to get it secured I stripped out the screw. There are no torque specs provided. I’ll move to crimped ring terminals on this one and dial back the torque a bit.
Used as a replacement for original connector that didn't have a positive fit. This one clicks in and provides confidence of a snug fit.
# 10
Hopkins Endurance 7-Way Trailer Connector Socket - Vehicle End - Ergonomic Design
Well I wasn't able to use this as there was no good place to install on my car without it practically dragging. Not a product problem at all. I tried to return and customer service was fast and super helpful... unfortunately return shipping would eat up any refund. So.. I get to keep it. good quality and product. Very happy with it and wish I could use it. Will keep it for sometime in the future when of course I will need it.
I do not recommend this product. I bought this for my truck. It seems to be the nicest looking plug on the market but after the first rain, the plug was filled with water. I changed the location from the hitch to the bumper and once again the plug was filled with water after it rained. This condition will obviously lead to terminals corroding and/or wires being shorted out. I have bought a different style plug, unfortunately the same brand but hopefully I will have better luck. May be able to drill a small drain hole in the casing to allow water to escape but shouldn't have to do this on a new product.
# 11
20 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 30" Ground
Right size for my application. Very pleased.
Just what I needed for my home-built bike carrier. My wife rides an e-tricycle and by the time I loaded the trike and a couple of bikes on this platform, you could not see the car's taillights or blinkers. This harness worked perfectly!
# 12
7-Way Molded Trailer Wire Connector, 6' Long
Only gave 4 stars because it was a bit confusing. I have a lot of auto wiring experience; from car stereos,amplifiers and all manner of accessories. All of the info on etrailer indicated that the color coding didn't match up. So I went into it disregarding the standard color coding, when in fact it was just as it should be.
Good thick rubber and plug works perfectly.
# 13
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
Çable good but after putting new 7way plug on truck cable wire colors did not match etrailers picture
7 pin connector separated from cable. I was expecting that "Molded Cable" meant that the connector was fused to the cable insulation but instead, the two separated almost immediately after I installed it. It still works fine as the wires are connected securely inside the connector but with the outer covering pulled out like this, I don't think it will last very long.
# 14
Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket - Vehicle End
As the video indicates, ensure that your vehicle wiring is the same as the 7 blade definitions. Mine was not. Had to determine what color wire connections to use for a 4 flat adapter use on a dolly.
Exact replacement
# 15
Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
Quick shipping, will order from them again!
# 16
Hopkins Endurance 5-Way Flat Trailer Connector - Trailer End - Ergonomic Design
The product arrived in a timely manner and undamaged. I have not used this 5 pole adapter yet, but the 4 pole adapter I previously bought from etrailer years ago is still working great. I have no reason to doubt that this adapter will function equally well. I appreciate the good products and customer service from Etrailer.
I needed the extra wire to run for multi-led lights mounted underneath the steps at the rear of my trailer, when in reverse trailering. This connector seems heavier-duty compared to many on the market and so far is still working well after a year or more. As with most products from etrailer, I haven't been let down yet. Here's a real special GOTCHA moment I had recently; My trailer jack stand, which I had purchased from my well-known and popular local trailer company to replace my original had rusted to pieces. I needed a replacement quickly and trusted I'd get a decent product and price as had been the norm over many years. Anyway, I purchased the new jack and wheel and brought them home to install myself. Upon taking the jack out of the bag it came in, I noticed a sticker from etrailer, yea. Before installing I went online, saw that my jack was less than half the cost I'd just paid, and realized I should have purchased the jack when I had originally shopped online at the start of this replacement process. I could have returned my over-priced items but decided I didn't have the time due to procrastination. I decided they could keep their extra profit on this purchase but I won't get fooled again and my local shop has lost my trust.
# 17
Pollak Heavy-Duty, 4-Pole, Round Pin Socket, Concealed Terminals - Chrome - Vehicle End
Items were simply “thrown in the box” WITH the hitch which was not secured properly. Heavy hitch then bounced around on electrical connectors, destroying them. Components should have been fastened to the hitch as the hardware kit was with strong tape instead of just thrown into the box by somebody! Refund issued.
Product arrived on time and as described. I used this for setting up our 2014 Wrangler Unlimited Sahara for a flat tow. Mounting hole spacing @ 2" o/c didn't match our Blue Ox 1126 draw bar so I fabricated my own intermediate bracket, polished it to aircraft tooling standards, then lacquered it before final assembly. I think the finished product came out nice.
# 18
Hopkins Endurance 6-Way Trailer Connector Socket - Vehicle End - Ergonomic Design
The stuff not here
Very difficult to make the wiring connections, I was afraid I’d have problems on down the road so, I took it out of circuit and threw it away
# 19
Hopkins Endurance 4-Way Flat Trailer Connector - Trailer End - Ergonomic Design
I rewired my light bar for my boat trailer with the items I purchased. Before I built the the light bar, every time I used my boat trailer I would waste valuable sailing or fishing time repairing faulty lights. The do not last long when you submerge them in salt water. This light bar now version 3.0 have given little trouble over the years
Great product. Works well when I had a broken connection on my 4 way plug end on my light-up hitch cover I bought from y'all a while back. Always a happy customer. Thanks, George.
# 20
Bargman 7-Way, RV-Style Connector w/ 6' Long Coiled Cable - Trailer End
I had to replace the old 7 wire cable because the male plug had been pulled off. I chose the WH54006-043 coiled cable. I used a 1/2 inch clamp to hold the cable up at the box and a Connect-to-Protect to hold up the male plug. The result Is clean and tidy. Thank you,
This should work great, installation is still on my to do list.
What our customers are saying:
"Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast."