# 1
Adapter 4 Pole to 7 Pole Vehicle End Trailer Connector
This product works as expected. There is not too much to the installation, just plug it in properly and mount the ground wire. I did not find an easy way to mount this to my wife's Odyssey, or to the trailer hitch (item# 75270). Luckily, I do prototype design and manufacturing. So I came up with my own solution. I designed and made my own bracket to mount the 7 pole to the trailer hitch. It works like a charm, and looks great!
i had to replace these two items as my dear daughter went down our goat path driveway too fast. they replaced the originals from etrailer from the prior year. shipping is timely and customer service actually helps! i wired from battery to controller to hitch myself, and everything fit.
# 2
Hopkins Endurance Multi-Tow 7-Way RV and 4-Way Flat Trailer Connector - Vehicle End
I was very surprised bt the next day delivery! little did I know you have a warehouse just miles from me. The part was the exact part, came with hardware and snapped onto the harness on our Motorhome, One and done.
Product has worked well. I like the way the cover opens really wide so it's easy to line up the plug. I installed it on my F-350 on a Ranch Hand rear bumber. The four screw holes holes ranch hand drilled for the screws where slightly off from the holes in your product so I had to rotate connector CCW and drill and tap four new holes.
# 3
Pollak 7 Pole to 4 Way Connector Adapter
I wanted one with a LED tester built into it to "trick" my SUV into thinking I had a trailer connected when really it was just a bike rack so the car didn't slam in it's brakes while reversing thinking it was something else. So I bought a different adapter. The picture slightly deceived me into thinking this had LED tester because the plug is attached by a rubber string (that I thought was a wire). So add another picture of the other side and that would eliminate my confusion. 4 stars because it probably works the way 99% of people would want to use it for.
Everything worked out well. On time and fits perfect. Attach hitch setup and my new Ridgeline. It comes with a 2" inch receiver and I have a full compliment of 1.25. stuff from my previous car. All from etrailer i must admit! so I needed the 2-1.25 reducer, a good lock, and the 7-4 reducer for my goodies! Thanks for the grest service
# 4
Pollak 6 Pole to 4 Pole Connector Adapter
Works really well.
I used this adapter to connect 4-way auxiliary tail lamps for a hitch-mounted bike carrier to a 6-way winnebago connector. It works fine for marker lights and turn signals but not for brake lights. I think there is a winnebago-specific wiring pattern that this adapter does not cover.
# 5
4-Way Flat Trailer Connector w/ 60" Harness and Wire Taps
Harness is well made and shipped quickly and packaged perfectly
Took about 15 to 20 mins total to remove all the covers,Matt’s etc Wiring it in is so easy, only 4 wires, Use blue butt splice connectors instead of the ones it comes with. You can buy a small pack of ten for about 3 bucks, by doing this you will never have to worry about a loose connection. The video tells you what color goes where. I like to put a small price of electrical tape over every connector I do. Looks more professional and the wires can never come apart.
# 6
48" Car and Trailer End Loop 4-Pole
As always,they had what I needed, good price, fast shipping.....and a video about how to use it. My go to place.
This wiring extension will do very nicely. I have a trailer with removable tongue.
# 7
Hopkins Endurance Multi-Tow Twist-Mount 7-Way RV and 4-Way Flat Trailer Connector - Vehicle End
My original equipment had reached its life. This allowed me to get rid of a 4-way to 7-way connector.
It was exactly what it said it was. Perfect replacement.
# 8
Adapter 4 Pole to 7 Pole and 4 Pole w/Test Lamps
Not too difficult to install, but I would recommend using a car lift so you don't have to work from your back (review includes wiring harness and Brake Controller)
Perfect . My new Subaru hitch has a flat plate to which the dealership attaché the 4-flat. I used “2 L-brackets” to accommodate the 90 degree bend of the adapter bracket.
# 9
Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Trailer End
Nice product & good value imo--it's very beefy and appears to be heavy duty---I know these are supposed to be temporary---that said this one replaced a Reese connector connector exact same style w/LEDs that was almost 17 years old before it failed--hopefully this lasts even close to that amount of time--I don't use this trailer daily usually not even weekly---so maybe with commercial trailer use this connector isn't for you..... It's my considered opinion that many of the fails are the result of a lousy install or someone disconnecting by pulling on the harness INSTEAD of grabbing the connector either way this gets an A+ from me
This is perfect. I needed an easy way to change the connector on the trailer I'm working on. It was an old pop up camper with an 8 pin connector mounted on the frame. but I only needed a 4 after rewiring it. So, out with the old and in with the new! Plus it's really easy to connect all the wires. Picture is not of the new connector but of the whole project I'm working on. I've since mounted all the running lights, tail lights etc.
# 10
35 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 42" Ground
Replaced the wiring and lights on my 1992 boat trailer. I was able to get everything needed from etrailer. I think Optronics is of the highest quality and recommend both etrailer and Optronics product.
Works very well after re-wiring trailer lights with waterproof distribution box.
# 11
Hopkins Wiring Harness with 4-Pole Flat Trailer Connector - Trailer End - 4' Long
Perfect! extra long so I got rid of all my bull crab wiring
This replaced a old plug.
# 12
48" Long 4-Pole Loop with Cover
I have now installed the following on my 2017 Wrangler: Brake light relay kit . Hopkins Towed vehicle Tail Light wiring kit. Blue Ox base plate. Blue Ox Patriot Portable RF Braking System. All of this has taken about 3 days of work spread out over a week or so. Overall it went well. Not too many surprises. Crawling around under a car at 71 is a bit of a strain but I'll get over it. I must say that Donna P. has been a wonderful source of great information and has stayed right on top of the process. eTrailer has been a great source for this project. I would recommend you all with no hesitation.
The items I ordered will allow me to adapt my utility trailer for transporting my sea kayaks. Curt and Hopkins are both quality manufacturers. On a shipping note, the box arrived at the Post Office broken wide open. Your shipping folks need to wrap small, heavy, items in bubble wrap. Then stabilize it with foam peanuts. Just putting it in a box then stuffing the box with craft paper does not cut it. Items were not damaged so I am good to go.
# 13
60" Car and Trailer End Loop 4-Pole
Thank you so much for having videos to show how to install the items I buy.too cool
Just what I needed, Thank you.
# 14
Hopkins 4-Way Flat Trailer Wiring Kit - Vehicle and Trailer Ends
My 12 ft utility trailer needed a makeover, I stripped it down, installed new boards, repainted I and installed new wiring and lights. I ordered the wiring and lights from etrailer and they arrived in about a week and everything I ordered arrived in perfect shape. It installed very easily and worked perfectly when connected to my vehicle. Thanks etrailer for delivering on quality products and great service. Marty, Peoria AZ
I decided this would be cheaper than any extension I could find, plus I'm going to shorten the wires anyways, so it's no big deal if it's in two parts already. I have a powered light adapter that's intended to be located outside, but I don't care for the idea of having that power wire running out to the hitch, so I'm going to use this kit as an extension so I can keep the adapter inside the car. My car has auxiliary wiring sockets to plug a trailer harness into, so I wont be using the included splices, but those look fairly decent. I would recommend packing those splice taps with grease, to keep water out if you use those sort of things. I usually don't
# 15
Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Vehicle End
I recently had a need for the Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Vehicle End - HM48190 to replace the faulty one on my van. It was easy to find what I needed on the site and the price was comparable to other sites I had visited. I decided to go with etrailer because I had previously ordered the hitch through them. I appreciated the fact that an email was sent out confirming that they received the order as well as a follow-up email telling me that the part was shipped along with providing the tracking number. The installation of the part was easy and took no time to complete. Overall it was a fine experience and if I need to order anything in the future, I will be sure to come back and order from etrailer.
Great product. Easy to install
# 16
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
Simple and easy to use; just plug it in and connect it to the trailer harness. Works like a charm!
Not installed yet but looks as good as one used before in a former vehicle. The actual adapter I received is "Reese", which is a reputable brand for towing accessories.
What our customers are saying:
"very easy to shop"