# 1
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens
Although this light looks the same, it is not. The hole pattern for mounting is different, and when I twisted the wires together, it did not light when turning on the lights. It is in still new condition and I will return it.
I ordered one of the amber-lensed units from etrailer a couple of years ago. That one is still working fine and I expect this one will work equally well now and into the future. They're a little pricey for what they are but they're an exact replacement for the ones on my camper, unlike the less-expensive alternatives I've found that have different spacing on the attachment screws. I don't need any more holes in my RV than I've already got, thank you very much.
# 2
Optronics Dual Bulb Trailer Clearance and Side Marker Light - Incandescent - Oval - Red Lens
After working on the old lights on my camper numerous times just prior to leaving on a trip and while traveling, I decided it was time to replace all of the lights. I purchased two new tail/brake lights, and four new side markers. The total price including shipping was just over $28 (I should have done this a long time ago). The lights arrived within 3 days of being ordered, and I was able to install them fairly quickly. I am so happy that I now have all six lights working perfectly, and shouldn't have to worry about them for a long time
After the light broke on my trailer I could not find a replacement at the original manufacture, my search at etrailer paid off with an exact replacement and at a great price. Shipping was fast and on time.
# 3
LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Oval - Red Lens
The lights I ordered were a oerfect replacement for my rv..
# 4
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Amber Lens
This was a replacement for the OEM marker light installed by Jayco. It failed within the first year, probably because it was installed upside down(drain holes in the amber cover facing up…) the light assembly is marked TOP. Oh well! I did check the other three and they were installed correctly and are still working… With the OEM part number I matched it to this part from Etrailer. Confirmed dimensions and placed the order. Note the new light comes without screws.
This is the second time I've purchased one of these from eTrailer to replace a failed clearance light on my coach. It is an exact replacement for the OEM light and works great, just like the one I replaced a couple years ago continues to do. Also, economy shipping was surprisingly fast.
# 5
Low Profile LED RV Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red
Etrailer sent in good working order and their videos of their products are very helpful for installation.
Light was a perfect match to the existing tail lights on my coach
# 6
Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
The light assemblys ordered were back ordered but shipped to me as soon as they were available. The fit was perfect. Had some problems with the wiring,the coach had 8 wires and the assy had 6. Once figured out the install went quickly. Perfect match.
Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.
# 7
LED Trailer Light w/ Reflector - Brake, Turn, Tail - Passenger Side - Oval - Red
Exact fit, and really fast shipping by etrailer. Only disappointment was that it didn't come with a new gasket.
This light was a perfect replacement for the original light that had failed. Super easy installation.
# 8
LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Oval - Amber Lens
These were really easy to install. I found that I needed more markers on the side of our 5th wheel trailer (44') I actually posted a few videos of people turning into our lane thinking they had passed the trailer. Connected to the rear and front marker lights and I have had no problems since.
These lights were a perfect replacement for the top marker lights on my motorhome. They were not available from the original manufacturer, only E trailer. Thank you guys for the great service and fast shipping.
What our customers are saying:
"Great trailer roof vent low profile cover. I just built an extra garage with a 9 ft door and my trailer didnt fit by less than an inch with the original bubble cover. This new cover gave me an extra 1 1/2 inches of clearance and solved everything. Price and shipping was great too. Thanks for saving me. Its hard to measure the actual trailer height and I dont think I wanted a 10 ft door."