How To Wire LED Stop/Turn/Running Light

Updated 04/30/2020 | Published 09/25/2014

Products Featured in This Question

Miro-Flex LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red

(425)

$26.22

LCD Digital Circuit Tester

(26)

$26.67

Question:

Hi, I am using the electronics LED oval lights as stop/turn/running lights in my buggy. My question is how do I wire the red stop/turn to my car? Will I just splice the wire with my brake circuit and turn circuits? It seems to me that doing it that way will make both lights flash when turn signals are used. If you have a general wiring diagram that would help immensely.

asked by: Thomas C

Expert Reply:

You should have 3 wires at the rear of your LED light, or from a pigtail like part # A47PB, that plugs into a light like part # STL22RB.

The red wire will be connected to your stop/turn circuit on your vehicle. The black wire is spliced into your running lights, or the lights that are turned on your vehicle when the headlight switch is on.

The white wire is your ground and needs to be attached to a clean, bare metal surface.

It may help using a circuit tester like part # PTW2992, to help identify the wires when installing the LED light. You can see which wire has power for the function you want to attach. I have attached a product review video for a taillight you can check out.

If you have a separate wiring system on your vehicle, you can use part # RM-732, which will take the separate wiring and convert it to a 2-wire system needed for the LED lights and pigtail.

I have attached a helpful article that explains trailer wiring.

expert reply by: Jeffrey L

Barry F.

4/28/2020

I bought LED lights for my trailer, the DS has five wires, black, red, white, green, bluethe P/S has four wires black, red, blueI ran power from a battery to a circuit tester and hook white wire up to a grd.I tried 12 volts to the colored wires buy no lights work?

Chris R.

4/30/2020

Do you already have the new lights hooked up to the trailer? I'm a little unclear on which wires are coming from the new assemblies and which are from the trailer. The best route here to ensure you made the right connections is to test each wire coming from the trailer to see which receives power with each light function activated on the tow vehicle.