How to Install the Redarc Tow-Pro Liberty in a 2024 Toyota Tacoma

Updated 06/27/2025 | Published 05/07/2025

Products Featured in This Question

Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional

(2234)

$190.00

Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob

(694)

$11.16

Question:

Where do I install the redarc trailer brake controller on a 2024 Toyota Tacoma??

asked by: Michelle C

Expert Reply:

Hey Michelle. Your 2024 Toyota Tacoma does not have a brake controller port so you'll have to install the Redarc Tow-Pro Liberty item # RED52VR by splicing it into your wiring. I have attached a diagram below so you can see how to get it set up.

The main part of the Tow-Pro can be installed behind your dash out of sight. We do have a unique mounting method for the control knob since you're installing it in a Toyota. You can use the Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob item # 331-TPSI-002, in one of your empty knockout panels. This will make the knob look like a factory accessory as shown in the picture below.

What kind of trailer do you have?

expert reply by: Jerred H

Redarc Tow-Pro Liberty
(click to enlarge)

2024 Toyota Tacoma
(click to enlarge)

Eric

6/26/2025

That doesn't really help though. I think they wanted actual instructions

Jerred H.

6/27/2025

@Eric That diagram is directly from the instructions. There's only four wires you have to connect to install the Redarc Tow-Pro Liberty item # RED52VR in a 2024 Toyota Tacoma.