Resetting TireMinder i10 TPMS

Question:

I have the TireMinder I10 monitoring system. I need to know how to set the overheating and over pressure parameters that the tires reach while traveling down the road. My warning alarm comes way to soon

asked by: Dan

Expert Reply:

Hey Dan,

Thanks for the purchase and to reset your TireMinder i10 # TM89FR you have to set up the installation process over again. Per TireMinder, here's the steps.

First, remove all transmitters from the valve stems and set them down by the tires.
From Monitoring Mode, press and hold the LEFT and RIGHT buttons for 5 seconds (until all 20 positions appear). The screen will show LEARN in the top center of the display.
You will see that all your currently active tire positions display a tire pressure.
Press and hold the CENTER and RIGHT buttons. After 5 seconds, the unit will beep twice, and each tire position will read “- -."
Since you are already in the Learn Mode, you may start the re-install process immediately.
If you are not ready, you should exit from this mode by pressing and holding the LEFT and RIGHT buttons until all 20 positions disappear.
You will be back in Monitoring Mode From here, you may start over at any time.