bing tracking image
Q & A Icon

Replacement for Older Go Power PWM-30 Solar Controller  

Updated 04/14/2025 | Published 04/05/2024

Question:

Do you sell the Go Power PWM-30 Solar Controller that is the older version and non-Blue Tooth? I have two of the older versions and one has gone bad. Will the Blue Tooth Go Power PWM - 30UL work in place of the older one?

0

Expert Reply:

Hi David, thanks for reaching out!

The older Go Power PWM-30 Solar Controller has been discontinued, but you can use the Go Power PWM Solar Charge Controller with Bluetooth # GP76QR along with the Installation Adapter Plate # GP86QR to replace it!

I confirmed this with my contact at Go Power.

expert reply by:
0
Jon G
David H. profile picture

David H.

4/5/2024

Thank you for your response. I tried the newer blue tooth version and could not get the screen to reset. It just kept flashing fast. I tried a soft reset and then a hard reset as reccomended in the install videos but still would not reset and just kept flashing and could not get it to work. Any suggestions if I order another one?

Jon G. profile picture
Etrailer Expert

Jon G.

4/5/2024

@DavidH I reached out to my contact with what you referenced is going on and they said it sounds like it may have been installed incorrectly or you might have a voltage issue. I recommend double checking all of the wiring to make sure it's been connected the right way. If your controller is still showing issues my contact said it would be best if you reached out to Go Power direct either at [email protected] or calling in at 866-247-6527.
David profile picture

David

4/5/2024

@JonG Thank you very much!
Jon G. profile picture
Etrailer Expert

Jon G.

4/6/2024

@David Happy to help out!
See All (4) Replies to David H. ∨
Aaron profile picture

Aaron

4/13/2025

In regards to your earlier reply “ The older Go Power PWM-30 Solar Controller has been discontinued, but you can use the Go Power PWM Solar Charge Controller with Bluetooth # GP76QR along with the Installation Adapter Plate # GP86QR to replace it! I confirmed this with my contact at Go Power.” Are the mounting holes in the plate the same as the old PWM Gopower controller? I should have asked before ordering yesterday, my order is still pending….not shipped yet. I do not want to make extra holes in my camper. Thank you.

Jon G. profile picture
Etrailer Expert

Jon G.

4/14/2025

@Aaron I reached out to my contact at Go Power and they said the mounting holes will match up so no additional drilling will be needed.
Aaron profile picture

Aaron

4/14/2025

@JonG Thank you very much! I hope it ships today :) ordered the other day.
Jon G. profile picture
Etrailer Expert

Jon G.

4/14/2025

@Aaron Happy to help! Hopefully they are able to squared away for you quickly!

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>