Can Cables Be Extended on NOCO GENPRO On-Board Battery Charger
Updated 05/30/2023 | Published 05/27/2023
Question:
Can I extend the eyelet cable length using an appropriate wire gauge?
asked by: Peter
0
Expert Reply:
Yes, you can extend the cables with the eyelets on the # NOC44FR. The 14AWG leads can be extended an additional 10' without modifying or moving the fuse. The fuse must remain in place and the additional length must be added after the fuse. Assuming you follow these guidelines you will not void the warranty.
expert reply by:
Robin H
0
Product Page this Question was Asked From
NOCO GENPRO On-Board Battery Charger - AC to DC - Waterproof - 1 Bank - 12V - 10 Amp
- Battery Charger
- Battery Charger
- Boat
- Electric Vehicle
- Generator
- Trolling Motor
- 12V
- Charges and Maintains
- AGM
- Gel
- Lead Acid
- Lithium
- Shore Power to Auxiliary Battery
- Smart Charge
- Trickle Charge
- NOCO
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Block Heater Recommendation for 2018 Toyota RAV4 Hybrid
- Q&A: Wiring Diagram for the Bulldog Powered-Drive Kit # BD1824200100
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Q&A: Looking For Lock Cylinder 509 On T-Handle
- Q&A: DC to DC Battery Charger Kit Recommendation for a Scamp Trailer
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Difference Between Titan Chains TC2327 and TC2533 for P275/55-R20
- Q&A: Parts Needed and Wiring Methods for Adding 110 and 12 Volt Power and Accessories to a Trailer
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today