Replacement Winntec 6000 Regulator

Question

Question:

I just got a recall on my 2018 HD imagine about a possible defect on the winn tec 6000 propane dual tank regulator. I cant seem to locate a replacement. Has this been discontinued and is it replaced by the 6020? Is there a compatible regulator I can use?

asked by: Steve O

0

Expert Reply:

The Winntec 6000 regulator that you referenced is a low pressure regulator like what the JR part # 37207-31525 you referenced. If it's a recall I'd imagine they'd replace what you have with something that would work but if not the # 37207-31525 would work great.

expert reply by: Jameson C

0

Answer 1

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the necessary…

view full answer...

Answer 2

The MORryde X-Factor Crossmember uses 2 of the Wet Shoulder Bolts #MR52HR. I recommend using the LubriMatic LMX Industrial Strength Grease #L11390 with these bolts. This grease is formulated to work well in both hot and cold climates. It is also…

view full answer...

Answer 3

When installing suspension components on your trailer there is not going to be a torque setting for the hanger bolts because they really only get tightened down to hand-tight. Going more than hand-tight can pinch the hangers closed and prevent the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Rob, A 7k axle would have a 3" diameter tube so the CE Smith U-Bolt Kit for Mounting 5.2K to 7K, Round Trailer Axles #CE23003 would be the correct fit. These kits are for one axle each so you'll need to purchase one for each axle on your…

view full answer...

Answer 6

Yes, the TorkLift Lock and Load SideKick #TLA7901 that you referenced will fit a Honda 2200 generator like you mentioned. We had the chance to fit one on this carrier and it worked well. See attached picture. It's also in the review video for…

view full answer...

Answer 7

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Replacement Winntec 6000 Regulator

Product Page this Question was Asked From

Continue Researching