Wire Gauge of USB Power Outlet for RVs - 2 USB Ports 37215115

Question

Question:

What gauge wire does this use?

asked by: Luke L

0

Expert Reply:

14 gauge wire is used with the USB Power Outlet for RVs - 2 USB Ports # 37215115.

So you can connect the wires with two of the Butt Connector - PVC - for 16-14g Wire # DW05714.

Then to mount it in the correct plate is the Mounting Plate for 12V Socket or USB Outlet # 37215155.

I have added some links below to video reviews for you to check out as well.

expert reply by: Kyle S

0

Answer 1

The hitch extender part #BX88265 will work but it will be close to exceeding the weight capacity of the hitch. You are correct, the tongue weight capacity of the extender is 1,000 lbs but you have to go by the capacity of the weakest component of…

view full answer...

Answer 2

While we don't carry any chargers with a USB-C port in them the real determining factor for the charging speed is going to be based on how many amps the charger can pull. With DC wiring they don't expect you to pull a large amount of amps so…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Hey Joe! We haven't done a lot of installations on the #3460001 and I believe we tied it into a factory switch on the one we did. I would say find any open spot in the dash nearby for installation like the picture below.

view full answer...

Answer 6

Hey Rueben, yes the Redarc Tow Pro Liberty brake controller part #RED24FR with the harness part #RED69FR is a fit for your 2007 GMC Yukon XL. This is one of the best brake controller solutions out there since it only puts a small knob on the dash of…

view full answer...

Answer 7

It looks like you've got a Kwikee step motor 5973820 and according to my tech contact at Lippert the correct replacement motor is the Lippert Components Kwikee Step Motor Replacement Kit #LC379608. This is a direct replacement for your old unit…

view full answer...

Answer 8

Hello Lyle; the Redarc Tow-Pro Liberty #RED24FR is my favorite brake controller so I think that is a great choice. With the factory tow package you should have a port under the dash that allows you to plug in the brake controller for installation…

view full answer...

Answer 9

Hello Brian, In order to install (2) of the #TLL44FB at the back bumper of your Super Duty you are safe using 14 AWG wire, if you plan on installing more lights in the future I would do the 12 AWG wire. You will also want to install a 5A fuse near…

view full answer...

Answer 10

Yes you are correct the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is the right replacement and measures 18 1/8" long and 16 1/2" wide, which is the same measurements as your current MaxxFan Plus Roof Vent w/…

view full answer...

Answer 11

Yes, you could splice into the wiring of the 12v light to power your MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 10 Speed - Smoke #MA00-06200K. Since the light you have on the ceiling has a switch on it the power wire is always…

view full answer...

Answer 12

The three roof vents offer very different ventilation solutions. If you are looking for the best way the MaxxFan part #MA00-06200K wins easily. It has a fan that moves 900 CFM (that's quite a bit) and a lid design that allows you to never have to…

view full answer...

Wire Gauge of USB Power Outlet for RVs - 2 USB Ports 37215115

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching