Is a Circuit Breaker Required When Installing Trailer Breakaway Switch?
Updated 08/02/2020 | Published 07/29/2020
Question:
Should we put a circuit breaker on the 12v hot wire between the trailer battery and the breakaway switch? If so, how many amp should it be? Thank you!
asked by: Steeve
1
Helpful Expert Reply:
When installing a breakaway system and the Replacement Tekonsha Trailer Breakaway Switch # 420000 you asked about, there is no need to add a circuit breaker or in-line fuse. I've attached a help article for the installation of a system as well as a video of an installation to assist.
expert reply by:
Jason S
1
Product Page this Question was Asked From
Replacement Tekonsha Trailer Breakaway Switch
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Tekonsha
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Breaking Down the B and B RV PowerVent Wastewater Tank Vent
- Video: Kodiak Disc Brakes DIY Installation - 2023 Grand Design Solitude Fifth Wheel
- Q&A: Once a Trailer Breakaway Switch Pin has Been Pulled is the System Reusable
- Video: HydraStar Electric Over Hydraulic Actuator Kit Installation - 2018 Grand Design
- Video: Breaking Down the Mounting Bolts and Hardware for 12-1/4" Single Brake Assembly
- Shop: B&B RV PowerVent Wastewater Tank Vent - Black
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Torque Specs for Installing Kodiak Replacement Mounting Bracket for Disc Brake Caliper
- Shop: 2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - White
- Shop: 2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - Black
- Search Results: roadmaster comfort ride
- Search Results: 9/16~18
- Search Results: 9/16
- Search Results: nut
- Search Results: brake line
- Search Results: never fail
- Shop: Replacement Tekonsha Trailer Breakaway Switch
- Video: Step-By-Step Installation Tutorial for the Suspension Bushing on a 1917 Ford Model T
- Q&A: Securing Axle U-Bolts With Loctite
- Q&A: Mounting Hardware For Dexter 8,000 lb Electric Trailer Brakes
- Q&A: Are Kodiak Caliper-Mounting Bracket Designed For Left Or Right Side Of Axle
- Shop: Mounting Bolts and Hardware for 12" Single Brake Assembly
- Shop: Dexter Brake Mounting Bolt for 8,000-lb to 9,000-lb Brake Assemblies
- Shop: Replacement Mounting Bracket for Kodiak Disc Brake Caliper - E-Coat - 8,000-lb Dexter Axle
- Video: Manufacturer Discussion - Roadmaster Comfort Ride System
- Video: Redline Trailer Suspension 117581 Review
- Search Results: inverter charger
- Q&A: Torque Specs of Mounting Flange Bolts on Dexter Nev-R-Adjust Electric Trailer Brakes
- Q&A: How to Wire Up a Breakaway Battery and an Auxiliary Battery on a Trailer without Backfeeding