Zero Point Calibration for Lippert Ground Control 3.0
Products Featured in This Question
Question:
We just bought a 2020 KZ Durango with a 3.0 leveling system. We have been trying to get it to work for 2 days. My husband leveled it manually. Where do we go from here. We only have the small control panel outside. It doesn’t have front and back buttons on it. Please advise on how to Zero so we can use the auto level system. We got nothing in our owners manual about using this system
asked by: Mary
Expert Reply:
Here are the instructions for the Zero Point Calibration for the Lippert Ground Control 3.0 # LC358590 or # LC675817:
1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center
of the trailer and leveling it both front to back and then side to side. (See “Basic Jack Operation” for
instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button (Fig. 18G) 5 times and then press and
release the “REAR” button (Fig. 18J) 5 times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set,
Power to Exit” (Fig. 19).
5. To set the current position as the zero point, press the “ENTER” button (Fig. 18C).
6. LCD display will read “Zero point stability check” (Fig. 20).
7. LCD display will read “Zero point set successfully” once process is complete (Fig. 21).
8. The system will set this point as its level state and the touch pad will turn off.
I have also added links to the instruction manuals for you.

Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Installation Of The Lippert Ground Control 3.0 Jack Leg Mounting Brackets
- Q&A: Can Lippert Ground Control 3.0 System Have Rear Jacks Mounted at Different Distance from Front Jacks
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Mounting Plate Height of Replacement I-Beam Jack Bracket for Lippert Ground Control
- Article: Trailer Wiring Diagrams
- Article: Performance Chips and Modules
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs