What Causes Grease Gun to Get Stuck on Grease Fitting
Published 09/12/2019
Question:
the greasegun connector willnot come off of greasefitting
asked by: D C
0
Expert Reply:
Grease guns get stuck on fittings due to clogged zerk fittings which don't let the grease pass through and cause a pressure build up that prevents them from releasing. So to get it unstuck unscrews the hose or hardline from the gun which will release the pressure and allow it to come off. You do need to clear out the zerk fitting though. There are solvents for this as well as grease gun like devices (we don't carry) that insert a high pressure solvent to break it up.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - 02475
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.250 Inch I.D.
- Bearing 02475
- Race 02420
- 8000 lbs Axle
- etrailer
more information >
Continue Researching
- Shop: Kenda Karrier ST205/75R15 Trailer Tire with Black Mod Wheel - 5 on 4-1/2
- Q&A: How To Choose The Correct Slide Out Awning When Dealing With Limited Clearance Space
- Q&A: Bearing Kit for Dexter Axle on 2021 Grand Design Momentum 351M
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Q&A: USA Made Bearing Kit that Fits 7k Axle of 2019 Grand Design 351M
- Q&A: Do Hub Races Have to Be Replaced Each Time Bearings Are Changed
- Q&A: Flat Towing A 2021 Chevy Spark
- Q&A: Recommended Slide Out Awning For A Slide Out With Limited Mounting Bracket Space