Recommended Winch Cover to Fit Badland 2500 Winch

Question

Question:

Do you know of A cover to fit Badland winche 2500 lbs. #61297, Thank you

asked by: Douglas A

0

Expert Reply:

The winch you referenced based on my research is 11.25 x 3.88 x 4.25. Based on these measurements the Bulldog Winch Neoprene Cover # BDW20192 will fit and has an elastic bottom with a hook and loop enclosure at the side.

expert reply by: Jason S

0

Answer 1

I went out to the warehouse and pulled Brophy hitch adapter #HT58 to take some measurements. The overall length of the 1-5/8 inch part is 4-3/8 from the end to the larger part but 4-1/8 inches when measuring to the weld bead. The overall length is…

view full answer...

Answer 2

The amount of cold cranking amps you need depends on how much you plan to lift/pull. The Badland Winch 2500 has an amp draw of 132amps at 2500 lbs, so any car battery should do. I would recommend including a charger in your setup. I recommend the…

view full answer...

Answer 3

You will want to use a circuit tester like part #PTW2993 and check the #4 terminal on the back of the 7-way trailer connector on your trailer for power. This is the 12-volt power terminal so there should be power to that terminal. You will need to…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

Wheel bolt patterns are defined by two numbers: the first being the number of lug nuts and the second being the diameter of the circle the lug nuts are arranged in. So a 5 on 4-1/2 bolt pattern is 5 lugs arranged in a circle that is 4-1/2 inches in…

view full answer...

Recommended Winch Cover to Fit Badland 2500 Winch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching