Resetting Lippert Ground Control Leveling System After Dead Battery

Question:

How do you rest lci leveling system after a dead battery

asked by: Kai I

Expert Reply:

For your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC675817 or # LC358590 you need to reset the leveling memory. The “Zero Point” is the programmed point that the trailer will return to each time the Auto Level feature is used and this is what needs to be reset after a dead battery. Here is how to set that "Zero Point" for leveling:

1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center of the trailer and leveling it both front to back and then side to side. (See “Basic Jack Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER” button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is complete.
8. The system will set this point as its level state and the touch pad will turn off.

expert reply by: Jason S

John K.

6/25/2020

tried to auto level on to steep incline rear jacks full down front jacks full up no jacks will move in any mode how do i reset the system?

Chris R.

6/29/2020

If the jacks won't move at all I recommend simply disconnecting the system from power, letting it sit for a bit, and then re-connecting it. Once it's back up hold down the enter and retract buttons at the same time and this should hopefully reset everything and resolve the issue.