How Does a Weld-On Bulldog Jack Install Onto a Trailer
Published 10/14/2011
Question:
gOT THIS JACK A FEW YEARS AGO AND DONT KNOW HOW TO INSTALL IT TO THE TRAILOR. hELP!
asked by: CHUCK M
0
Expert Reply:
This Bulldog Round, Snap-Ring Swivel Jack # BD151101 is a weld on jack. You will need to remove the mounting bracket from this unit and have it welded to the frame of your trailer near the coupler and then reinstall the rest of the jack on to the bracket and you will be good to go at that point.
I attached a link to the installation instructions for this product for you to check out also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Round, Snap-Ring Swivel Jack - Sidewind - 10" Lift - 2,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Fix For Curt Echo Wireless Brake Controller Locking Up Trailer Brakes At Low Speeds
- Article: Trailer Wiring Diagrams
- Video: Bulldog Square Jack Review
- Video: An In-Depth Look at the Bulldog Square Jack
- Video: A Closer Look at the Bulldog Square Jack
- Video: All About the Bulldog Square Jack
- Video: Pro Series Square Jack with Footplate Review
- Search Results: bulldog trailer jack
- Search Results: bulldog jacks
- Search Results: ram trailer jacks
- Search Results: 10k trailer jack
- Search Results: pro series trailer jack
- Search Results: trailer jacks
- Shop: Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Shop: Square Jack w/ Crank - Side Pin Drop Leg - Spring Return - 10K Lift - 25-3/4" Travel
- Shop: Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-3/4" Lift - 10K
- Shop: Bulldog Square Jack - Side Pin Drop Leg - Spring Return - 10K Lift - 26" Travel
- Shop: etrailer Square Jack - Foot Lever - Drop Leg - Spring Return - 12K Lift - 26-1/2" Travel
- Shop: Bulldog Square Jack - Drop Leg w/ Non-Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Shop: Bulldog Square Jack - Drop Leg w/ Non-Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Q&A: Proper Mounting Location for Side Marker Lights on a Trailer
- Q&A: 5200 lb Dexter Hub Bearing Kit Recommendation
- Search Results: battery box
- Q&A: How To Replace Welded-On Trailer Tongue Jack for Boat Trailer
- Q&A: What Grease do you Recommend for my Trailer Surge Brake Actuator
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Rooftop Cargo Carriers
- Q&A: What Difference Between Max Output and Sensitivity Setting for Curt Echo Mobile Brake Controller
- Article: RV Sway Control, Stabilization, and Suspension Enhancement