Replacement for Shelby Boat Winch

Question

Question:

I am looking for parts for a Shelby boat winch and when I Google it they come up under Fulton? are the same? do you have parts for the Shelby winches? Looking for the ratchet repair Kit? Thanks

asked by: Randy J

0

Expert Reply:

Shelby is no longer in business and would not be the same as Fulton; there are no ratchet repair kits available for Shelby so you'll need to replace your winch. Keeping in mind that a boat trailer winch has a boat-size-to-winch capacity that is generally 2-to-1, I recommend checking out the Single-Speed Boat Trailer Winch with 20' Strap and Brake # 315-W2000D.

This winch has a 2,000 lb capacity, has a self-locking crank and is zinc-plated so you do not have to worry about it getting corroded.

expert reply by: Kyle S

0

Mike M.

6/3/2020

I want to replace my Shelby 5405 boat winch with a 2 speed winch about the same dimensions

Reply

Chris R.

6/7/2020

I think the closest option we have is the Dutton-Lainson # DL14825, which features a 2,500 pound capacity and 2 speeds. I've linked an answer page below that calls out its dimensions so you can compare it to your existing Shelby 5405.

Helpful Links

question-337048.html

Reply

Answer 1

The Dutton-Lainson Hand Winch part #DL15303 is the replacement that I recommend for your Shelby Hand Winch 5405. These winches both have the same 1,400 lb capacity and overall size. In regards to mounting, most hand winches now use a standard pattern…

view full answer...

Answer 2

I went out to our warehouse so I could take some measurements on the Dutton-Lainson Hand Winch #DL14825 that you referenced. The main body of the winch measures 7 inches long, 5 inches tall, and 4-7/8 inches wide. With the wheel its length is 9-1/2…

view full answer...

Answer 3

The DICO 189 you referenced is the older version of the Titan 60. You will want to replace the master cylinder with the Replacement Master Cylinder Assembly for Titan Model 60 and Aero 7500 Brake Actuators - Drum #T4395100. I've attached a video…

view full answer...

Answer 4

For a switch to supply or remove power going back to the gate you can use a simple on/off switch such as #PK34213. This switch is rated up to 50 amp applications. For a switch that has 3 positions you could use on/off/on switch #PK34218 which is also…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

I am almost certain that the issue is that the connector on your 2015 Chevy Silverado 2500 and the one on the trailer are pinned out differently. I have included a picture that shows how a vehicle and trailer side 7-Way are wired (ignore the colors…

view full answer...

Answer 7

There are a few things that can cause the brakes to lock up on a trailer. First, disconnect the trailer from the vehicle. Then use a circuit tester like #PTW2979 if needed to test the connector on the vehicle. Have someone sit in the truck and run…

view full answer...

Answer 8

Trailer axle nuts don't have a torque rating as you don't want to run them down super tight. The trick is to tighten the nut till there's no play in the hub in and out with the wheel installed and then use the cotter pin to hold the nut…

view full answer...

Answer 9

We have some very similar winches to the Shelby 5466 that you have but we do not carry Shelby winches any longer. The Shelby is a 2 speed winch with a 2,300 lb capacity so for a very similar winch we have the Dutton Lainson 2 speed winch part…

view full answer...

Answer 10

I do have a solution for you, but it will not include replacing a wheel on your existing winch. Your Shelby Winch, model 5351, is a 1,000 lbs winch with a 2-way ratchet. If you need to replace your existing winch I recommend a winch by Dutton…

view full answer...

Answer 11

The Dutton-Lainson Hand Winch w/ Automatic Brake - TUFFPLATE Finish - 2,500 lbs #DL14958 you asked the question from is a great option for your boat lift. This is a very nice option that will keep the handle from free-wheeling and possibly hurting…

view full answer...

Answer 12

Shelby has gone out of business and as such there are no replacement parts we can offer for your Shelby 5470 winch; due to that the best option is going to be a replacement winch. For this I highly recommend the Dutton-Lainson Hand Winch #DL14825…

view full answer...

Replacement for Shelby Boat Winch

Product Page this Question was Asked From

Continue Researching