Landing Gear Switch Installation and Wiring Diagram

Updated 04/10/2024 | Published 06/07/2018

Products Featured in This Question

Replacement Switch for Stromberg Carlson Electric Landing Gear

(62)

$67.01

Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs

(37)

$196.22

Question:

Where do the four wires on the landing gear switch connect. Pink, Red , black, and black ?

asked by: Bill C

Expert Reply:

The Replacement Switch for Stromberg Carlson Electric Landing Gear # LG-145236 has the wiring colors you specified and will connect in the manner shown in the attached photo. The pink will connect to the positive battery terminal. The short black will attach to the negative battery terminal. The long black will connect to one side of the motor and the red to the other side of the motor. These wires will change the direction the motor turns, so you will want to make sure they are connected to the proper side based on your motor mounting location. Some motors are color coded to assist like the motor and switch kit # LG-217884.

expert reply by: Jason S

click to enlarge

Jerry S.

2/29/2020

I have a fifth wheel that the jacks dont work, I replaced the switch but the new one has a red wire a black wire blue wire and a white one. The wires in the fifth wheel wiring is two red wires and two black ones I can get them to extend but not retact any suggestions?

Chris R.

3/2/2020

Can you tell me what brand/model jack system you have? Unfortunately I wouldn't be able to verify the correct wiring connections without knowing what specific model switch is being used. Hopefully fixing this issue is just a matter of swapping one of the wires to the motor, but it's hard to tell for certain.

J L.

3/22/2024

my replacement landing gear switch has two black wires of same length trying to determine which one goes to battery ground and which to black motor wire

Mike L.

4/10/2024

@JL You'll just want to try it both ways. If the legs raise when you push the rocker switch down, then the polarity is reversed and you'll want to swap the wires the other way.