How to Install the TorkLift StableLoad Part # TLA7200 on a 2003 Ford F-350

Question:

I have a 2003 Ford F-350 Superduty 6.0 Diesel and am looking to install the TLA7200 but looking at the factory at this part it obviously bolts into place. However the current pad installed is not bolted on. It appears that it is rubber formed into a groove mount. I dont see any bolt that is holding the current pad in place.

asked by: Dave H

Helpful Expert Reply:

Yes you are correct in that the factory rubber contact pad is not bolted to the bump stop mount but rather pressed in. To remove this part you will need to soak the rubber pad in a lubricant. Once soaked you can then use a prybar to try and wedge the rubber pad out of place. This will take awhile to get the right angle so give it some time. Once the factory rubber pad is removed you can bolt the TorkLift StableLoad Suspension Upgrade for Upper Overload Springs part # TLA7200 into place. This will not require any drilling and can all be seen on the print instructions which I have attached for you.

expert reply by: Conner L