Removing Curt T-Connector Vehicle Wiring Harness # C56170 from 2013 Honda Pilot to Install on 2014
Updated 04/29/2015 | Published 04/28/2015
Question:
Part number CURT 56170 I need to remove the harness from the inside compartment of a 2013 Honda pilot. Is there a special trick to get the connectors to release? I dont want to break the connectors...
asked by: Ray K
1
Helpful Expert Reply:
On the vehicle side of the connector there should be a small tab that will need to be slightly lifted, which typically can be done with a very small screwdriver, while pulling the two connectors apart.
expert reply by:
Leah S
1
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Search Results: harness tester
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Shop: Brake Controller
- Q&A: Parts Needed to Install Brake Controller in 2014 Honda Pilot
- Q&A: Recommended Wiring Harness for a 2015 Honda Pilot EX 4WD without Tow Package
- Q&A: How Do The etrailer Single Axle Trailer Fenders Install?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Complete Tow Package for 2020 Honda Pilot to Tow 5,000 Camper with Brakes, Hitch, Wiring, Ball Mount
- Q&A: Brake Controller for a 2012 Honda Pilot
- Q&A: What Is Needed To Install a Brake Controller On a 2014 Honda Pilot